Carmanah R829-G Enerji Yönetim Sistemi Değiştirme Kılavuzu - Sayfa 10

İnşaat Ekipmanları Carmanah R829-G için çevrimiçi göz atın veya pdf Enerji Yönetim Sistemi Değiştirme Kılavuzu indirin. Carmanah R829-G 12 sayfaları. Cabinet-based systems
Ayrıca Carmanah R829-G için: Hızlı Başlangıç Kılavuzu (16 sayfalar), Manuel (11 sayfalar), Dolap Kapağı Değiştirme Kılavuzu (10 sayfalar), Manuel (9 sayfalar), Manuel (10 sayfalar), Kurulum Kılavuzu (14 sayfalar), Manuel (10 sayfalar), Manuel (10 sayfalar)

Sayfayı Yazdır
Carmanah R829-G Enerji Yönetim Sistemi Değiştirme Kılavuzu
3.2

Installing Replacement Energy Management System

1. Remove the new EMS from its antistatic bag and secure it to the enclosure with the four previously
removed screws. Sensitive electronics can be damaged by electrostatic discharge (ESD). Observe proper
ESD precautions when installing the new EMS.
a. You will receive either a bare EMS or one preassembled to a new enclosure. The new enclosure
is for older legacy R920/R247-E systems that originally used a smaller EMS and enclosure
footprint.
b. For replacement controllers that come preassembled to the enclosure you can discard the
existing enclosure. Copy over the existing system settings and system serial number (10 digits)
onto the new label on the front of the enclosure. This will help retain the original system serial
number for future tracking purposes.
2. Beginning with the solar panel wires, check that the wire strands are straight and that all the strands will
go into the terminal. This will avoid short circuits.
3. Reconnect all wires with the correct polarity as shown in
the terminal but you may use a small flat head screwdriver to push to down on the wire release button
while inserting the wire as needed. Ensure wires are fully inserted. Carefully pull on the wires to ensure
they are secure.
4. If the optional radio is present carefully connect the antenna to the new EMS. Push down on the radio
module while tightening the antenna connector and ensure it is snug.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
ENERGY MANAGEMENT SYSTEM
REPLACEMENT GUIDE
Section
2. The wire can be pushed directly into
|
carmanah.com
10