Advanced Keys AK-PSB05 Kurulum Kılavuzu - Sayfa 12

Otomobil Aksesuarları Advanced Keys AK-PSB05 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Advanced Keys AK-PSB05 15 sayfaları. Push-start ignition system

Sayfayı Yazdır

KEYSENSE FUNCTION BYPASS (OPTIONAL)

Most vehi c le has an mechani c al key trigger that gets activated when a key is inserted into the key

cylinder. Keysense input usually activates certain pre-programmed reactions such as (not limited to)

door-chime, turn ON dome light, headlight and instrument cluster illumination, disabling the OEM

remote/key's ability to lock/unlock doors and rel e ase trunk etc. Since the steering column lock bypass

require a key to be present in the cylinder, some

Check and verify Keysense input polarity and connect as follow:

• (+)Bypass Module Control Output to Positive Triggered Keysense Input

• (-)Ground-When-Running Output to Negative Triggered Keysense Input

Ignition

Switch

Positive Triggered

Note: Wiring method above is intended as a general reference and it does not necessarily represent the specific

vehicle requirement.

PUSH-START BUTTON INSTALLATION

This system features a standard Toyota design/manufactured push-start button switch whi c h provide

OEM look as well as tested durability. Install / mount the push start button on a firm and flat surface that

is directly accessible and within an

below. An exact 40mm±0.25mm diameter circular cut-out is needed to securel y mount the button

without the Button Ring Mount. When i n stall with the Button Ring Mount, the circular cut-out can be

between 40-45mm. See Push-Button Cut-Out section below for detailed method in making a cut-out.

Unused Switch

Blanking Cover

Knee Bolster, Lower Dash or

Cigarette/Power Port

Push-Button Cut-Out

If availabl e , use a hol e -saw to drill a 40mm cut-out. If an exact hol e -saw is not availabl e use following

method to make the cut-out:

1. Place a template against the desired installation spot and trace a 40mm diameter circle.

2. Create openings on the inside of the circle with a drill or soldering iron.

3. With the help of a cutter, connect the openings to cut out the material in the middle.

4. Use a round file to smooth the edge until button can be fitted in the cut-out tightly.

Insert the push-button along with the wire and connector through the Button Ring Mount and the cut-

out. Push the button down until fully seated around the Button Ring Mount over the cut-out. Apply

adhesive to the Button Ring Mount backing if desired.

To (+)Keysense

Push-Start Module

Bypass Module Control (+)

(Orange 22AWG)

reach by the driver. Use suggested locations as shown

Button Ring Mount Ø 55.7mm

Electric Drill

Soldering Iron

keysense trigger may need to be bypassed.

Ignition

Switch

Negative Triggered

Push-Start Button Ø 41.5mm (Chrome)

Cut Out

To (-)Keysense

Push-Start Module

Ground-When-Running (-)

(Grey 22AWG)

40.5mm

7.5mm

Sanding Rod