Dreamiracle HIM-35B Kullanıcı Kılavuzu - Sayfa 7

Buz Yapıcı Dreamiracle HIM-35B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dreamiracle HIM-35B 12 sayfaları.

OPERATING INSTRUCTIONS

Step 1

Open the lid and take out the basket and add water to the reservoir.

Note: There is a maximum scale MAX in the reservoir. The water should not

exceed the MAX position. If the water exceeds the maximum scale MAX,

you need to open the bottom drain plug, release the excess water, and

cover with a transparent cover.

Step 2

Plug in the power and press the ON/OFF button to start the machine.

In the ﬁrst three cycles, the ice is small and irregular.

When the ice basket is full, please take out the ice immediately, do not let

the ice overﬂow the ice basket.

CLEANING & USE GUIDANCE

1. Clean the inner liner, ice collecting tray, water box, ice shovel and

evaporator frequently. When cleaning, unplug the unit and remove the

ice cubes. Use a diluted solution of water and vinegar to clean the inside

and the outside surface of the Ice maker. Do not spray Ice maker with

chemicals or diluted agents such as acids, gasoline or oil. Rinse

thoroughly before starting.

2. Keep ventilation openings in the appliance enclosure, or in the built-in

structure, clear of obstruction. Do not use mechanical devices or other

means to accelerate the defrosting process, other than those

recommended by the manufacturer.

3. Reuse the machine after being idled for a period of time, it may not have

enough water to pump for air retard, in this case, the water shortage

indicator "ADD WATER" will light up, repress ON/OFF button to restart

the ice maker is okay.

4. To ensure the cleanliness of ice, please change water from water

reservoir at least once one day. If you do not use if for a long time, please

drain the water out and clean it up.

5. If the compressor takes a strike action for shortage water, fully water or

interruption of power supply, it will delay for 3 minutes to start up after

restarted.

6. Always use fresh water before starting ice production either at initial

installation or after a long shut-off period.