Formula Sound FF2.2 Kullanıcı Kılavuzu - Sayfa 5

DJ Ekipmanları Formula Sound FF2.2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Formula Sound FF2.2 15 sayfaları.

The headphone volume control sets the level at the headphone output, start with the volume set to

low and establish a signal in the headphones before increasing the headphone volume. Take note

of channel metering when switching CUE from one channel to another as levels may be very

different on different channels and this will be reflected in the sound level at the headphone output.

Hearing damage is a function of sound level and time, high sound levels should be avoided to

avoid hearing damage, work with moderate headphone levels.

The CUE mix control provides any signal present from channels with CUE selected at one end and

the master output signal at the other end with a mix in between.

The PRE-EQ switch makes the CUE on channels 1 and 2 pre EQ. The split switch provides the

master signal on one side of the headphones and the CUE signal on the other.

Crossfader

The XF buttons on channels 1 and 2 assign channel 1 to the left of the crossfader and channel 2 to

the right. So with channel 1 selected the cross fader in the left position will send the channel 1

signal at full level to the master and as the fader is moved to the right the level of channel 1 will

reduce.

Similarly with channel 2 selected, cross fader in the right position will send the channel 2

signal at full level to the master as the fader is moved to the left the level of channel 2 will

reduce.

The level of the mix of channel 1 and channel 2 on the middle section of the cross fader is

determined by the fader curve which is set by a control in the output section. The fader curve

control varies the rate at which the cross fader transfers between channel 1 and channel 2.

There is a switch accessible through the base which turns the cross fader off if required.

FX wet/dry

Channel 1 and channel 2 each have a switch to send that channel to the FX send jack and

return the signal at the FX return jack. The wet/dry control has the send signal at one end

and the return signal at the other allowing the user to sweep from no FX to full FX content by

rotating the wet/dry pot end to end.

Only one FX switch should be selected at any one time otherwise both channel 1 and

channel 2 are simultaneously sent and returned. The FX switch should be selected with

channel fader down.

Input Section

Inputs

Channels 1 and 2 are almost identical, the difference being channel 1 assigns to the left of

the cross fader and channel 2 to the right of the cross fader.