Andersen 40 STE Manuel - Sayfa 7

Vinçler Andersen 40 STE için çevrimiçi göz atın veya pdf Manuel indirin. Andersen 40 STE 17 sayfaları. 2+1 speed
Ayrıca Andersen 40 STE için: Manuel (8 sayfalar)

Sayfayı Yazdır

46STE Compact Above Deck up to version 3.2

Tools required for this conversion:

Allen keys 4mm and 5mm

Small screwdriver

Winch-handle

1. Remove the winch from its mounted position. Place the

winch drum and self-tailing arm to one side.

2. Remove the 6 or 9 screws holding the upper base to the

lower base. (Figure 1)

3. Remove the drive shaft from the upper base by pulling the

shaft upwards. To do this you can use a winch handle to pull

on the shaft. An o-ring stops the drive shaft from falling out

so some resistance should be expected when removing the

drive shaft. (Figure 2)

4. Turn the upper base upside down and remove the 2 free

gear assemblies by unscrewing the axels in the upper base.

(Figure 3)

5. Remove the complete roller bearing by sliding the ring

upwards. (Figure 4)

6. The old upper and lower bases are no longer required.

7. Reassemble the winch with the new upper and lower base

provided with your compact motor. While the winch is

disassembled it may be appropriate to carry out a general

service on the winch as described in the 46ST manual. In all

cases the gears should be cleaned and new grease applied

to all moving parts.

8. After first securing your new Compact Electric Motor to the

deck, the converted winch can now be mounted on the

motor with the screws provided.

Page 7 of 17

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5, Parts to be mounted

on the new upper base