Andersen 40ST FS Ürün Kılavuzu - Sayfa 4

Vinçler Andersen 40ST FS için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Andersen 40ST FS 8 sayfaları.
Ayrıca Andersen 40ST FS için: Manuel (9 sayfalar)

Sayfayı Yazdır

MOUNTING INSTRUCTIONS

Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the

position numbers in the parts list.

Tools required for the installation:

• Allen key (4 mm)

• Allen key (5 mm)

• Ø6.5 mm (1/4") drill

• Bedding compound

1. Drill bolt holes Ø6,5mm (1/4") using the winch template.

Be sure that no dust comes in contact with the winch, while drilling.

2. Remove screw (1) and top cap (2).

3. Remove self-tailing arm (3) and drum (5).

4. Apply a light coat of bedding compound on the bottom of the base (16).

Ensure that each bolt hole is bedded. Keep drain grooves clear.

5. Fasten base (16) into place using 5 pcs. M6 (1/4") countersunk head screws.

Use large washers or a backing plate.

6. Assemble in reverse order.

7. Check that the winch is functioning correctly:

- The drum should operate smoothly, when turning the drum clockwise by hand.

- The drum must not turn when trying to turn the drum anti clockwise by hand.

- While turning the winch handle clockwise the drum should turn slowly.

- While turning the winch handle anti clockwise the drum should turn quickly.

PAWL SPRING MOUNTING

Note the curved

spring "arm"

40ST (V.5.0)

40ST FS (V.5.0.F)

• 5 x M6 (1/4") countersunk head screws and corresponding

nuts (length depending on deck thickness)

• 5 x large washers or backing plate

• Ring spanner to match nuts