Andersen 58 ST E1 Ürün Kılavuzu - Sayfa 6

Vinçler Andersen 58 ST E1 için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Andersen 58 ST E1 18 sayfaları. Single speed electric motor unit, 12v & 24v

Sayfayı Yazdır

INSTALLATION INSTRUCTIONS

STEP 1 - Positioning the winch and motor unit

• Position the winch drilling template [A3] in the required position on the deck, ensuring that there

is adequate flat space for the deck plate/ winch base.

• The 58 & 62 ST winches have the option of eight different self-tailing arm positions as indicated

on the drilling template (refer page 16).

• Considering the product dimensions, shown on page 15, check that there is adequate space

below deck for the motor unit. You may choose to drill a small pilot hole to indicate the position

of the center of the drive shaft, to assist with this.

*Note: The motor unit can be installed in eight positions around the center of the drive shaft

(i.e. at 45° increments), to facilitate fitting the motor unit into restricted under-deck cavities.

See page 15 for the minimum motor offset dimensions at the various positions. Placing the

winch base on the motor unit in the various positions prior to installation can assist with

visualising the motor position options.

*Note: To ensure the correct functioning of the winch, it should be positioned with the correct

line entry angle of 3-8° below horizontal. Refer to the winch product manual for details of

correct line entry angle and self-tailing arm positioning.

STEP 2 - Fitting the deck plate base

• After it has been confirmed that there is adequate space for the winch above deck, and for the

motor unit below deck;

• Drill Ø10.5mm holes for the M10 winch base mounting bolts as per the drilling template [A3].

Drill Ø1/2" holes if 3/8" bolts are being used.

• Drill or cut a Ø66mm (2 5/8'') hole for motor drive shaft housing as per the drilling template.

*Note: Clean the deck hole before attempting the install the motor so that

the motor flange does not catch splinters of fiberglass or wood when being inserted through

the deck. Clean the deck with a suitable solvent to ensure the sealant can adhere properly.

• Apply sealant to the deck where the winch base will be fitted. For aluminium boats use a galvanic

isolating ring/gasket.

• Fit the winch base to the deck using appropriate length M10 (or 3/8") bolts, large backing washers

or plate, and Nyloc nuts.

E1 Single Speed Electric Motor Unit, 12V & 24V

To Suit Self-Tailing Winch Sizes 58,62