Electrolux A01061301 Kullanım ve Bakım Kılavuzu - Sayfa 7
Dondurucu Electrolux A01061301 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Electrolux A01061301 23 sayfaları.
Sayfayı Yazdır
Door Handle
Mounting Instructions
1.
Remove handle from carton and any
other protective packaging.
2.
Position freezer handle end caps
over upper and lower pre-installed
shoulder bolts (A) that are fastened
into door, ensuring the holes for
the set screws are facing towards
the outside of door if a single unit
installation or the refrigerator door (if
installing the matching refrigerator)
3.
While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
4.
Repeat steps 2 and 3 to install
refrigerator handle (if installing the
matching refrigerator). Ensure the
holes for the set screws are facing
towards the refrigerator door.
NOTE
All set screws should be tightened and
sub-flush (Allen set screw should be seated
just below the surface of the end cap) of
handle end cap. The end caps should be
drawn tight to door with no gaps.
Toe Grille Removal
To remove the toe grille, use a Phillips
head screwdriver and remove the two
screws holding the toe grille to the
cabinet. Then pull the toe grille away from
the unit.
Leveling
•
The freezer must have all bottom
corners resting firmly on a solid floor.
•
The floor must be strong enough to
support a fully loaded freezer.
•
It is VERY IMPORTANT for your
freezer to be level in order to function
properly. If the freezer is not leveled
during installation, the door may be
misaligned and not close or seal
properly, causing cooling, frost or
moisture problems.
Installing Door Handle
A
B
Single Unit Installation
Ensure handle set screws
are facing each other
Matching Refrigerator and Freezer Door
Handle Installation
with doors closed
Toe Grille
Remove
Screws
7