Electrolux ARCTIS Kullanım Talimatları Kılavuzu - Sayfa 31

Dondurucu Electrolux ARCTIS için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Electrolux ARCTIS 36 sayfaları. Electronic freezer no_frost

Sayfayı Yazdır

Malfunction

The appliance is over-

cooling.

The freezer compartment

temperature is insufficient.

Interior illumination does

not function.

Accumulation of frost at

the door seal.

Unusual noises.

The compressor does not

start immediately after

pressing the TURBO/

FROSTMATIC button, or

after changing the

temperature setting.

818 35 94-01/2

Possible cause

The temperature has been

set too low.

Temperature is not properly

adjusted.

Door was open for a long

time.

Within the last 24 hours a

large quantity of warm

foods were loaded.

Appliance is next to a

source of warmth.

Light bulb is defective.

Door is not properly sealed

(perhaps after reversing

the door).

Appliance is not level.

Appliance is in contact

with wall or other objects.

A part at the back of the

appliance, e.g. a tube, is in

contact with another

appliance part or the wall.

This is normal, no error has

occurred.

What to do if ...

Remedy

Temporarily select a higher

temperature setting.

Please refer to the section

"Temperature Adjustment".

Only leave the door open

as long as necessary.

Press TURBO/FROSTMATIC

button.

Please refer to the section

"Installation Location".

Please refer in this chapter

under "Replace light bulb" .

Carefully warm the door

seal with a hand-held hair

dryer at those points which

are not airtight (no warmer

than approx. 50°C). At the

same time, shape the

warmed door seal by hand,

so that it is again properly

seated.

Readjust the front levelling

feet.

Push appliance away a

short distance.

Bend this part away

carefully if necessary.

The compressor starts after

a period of time.