Bosch 6 Series Kullanım Kılavuzu - Sayfa 14

Sayfayı Yazdır

Basic settings

Cooking with the automatic programmes

With the 3 cooking programmes, you can cook rice,

potatoes or vegetables.

Notes

Ovenware

■

The food must be cooked in microwaveable

cookware with a lid. For rice, you should use a large,

deep dish.

Preparing food

■

Weigh out the food. You need to know the weight to

set the programme.

Rice:

Do not use boil-in-the-bag rice. Add the required

amount of water, as specified on the packaging. This

is usually two or three times the quantity of rice.

Potatoes:

For boiled potatoes, cut the fresh potatoes into

small, even-sized pieces. Add one tablespoon of

water for each 100 g boiled potatoes, and a little

salt.

Fresh vegetables:

Weigh out the fresh, trimmed vegetables. Cut the

vegetables into small, even-sized pieces. Add a tbsp

water for each 100 g vegetables.

Signal

■

While the programme is running, a signal sounds

after some time. Stir the food.

Resting time

■

Once the programme has finished, stir the food

again. You should leave it to stand for another

5 to 10 minutes until it reaches an even temperature.

The cooking result will depend on the quality and

consistency of the food.

Programme no.

Cooking

P 05

Rice

P 06

Potatoes

P 07

Vegetables

Combicooking programme

Notes

Ovenware

■

Cook the food in ovenware which is not too big, and

is heat resistant and microwaveable.

Preparing food

■

Take the food out of its packaging and weigh it. If it

is not possible to enter the exact weight, you should

round it up or down.

Resting time

■

Once the programme has finished, allow the food to

rest for another 5 to 10 minutes so it reaches an

even temperature.

Programme

no.

Combi programme

Frozen bake, up to

P 08

3 cm deep

Cookware

Weight range in

With lid

0.05 - 0.2

With lid

0.15 - 1.0

With lid

0.15 - 1.0

Cookware Weight range in

Open

0.4 - 0.9

QBasic settings

Y our appliance has basic settings that you can change

B a s i c s e t t i n g s

to suit your needs.

Setting

Options

Button tone

‚

Demo mode

š"‹

* Factory setting (factory settings may vary depending on the appli-

ance model)

You can change the button tone on your appliance if

you wish.

Changing the button tone

The appliance must be switched off when you do this.

Press and hold the start and stop buttons at the

same time for a couple of seconds.

will appear in the display.

‚

Touch the start button.

will start flashing in the display.

Turn the rotary selector to

Touch the start button.

The setting has been applied.

Touch the stop button.

The button tone has been switched off.

You can change this setting at any time.

Switched on

Switched off

Button tone (will remain active for

the start and stop buttons)

The appliance is switched off. You

can use the buttons and the display,

but the buttons will not activate any

function on the appliance (i.e. the

microwave has no power). Demo

mode is mainly used by dealers.