Community Distributed Design DS8 Kurulum ve Çalıştırma Bakım Kullanıcı El Kitabı - Sayfa 7
Konuşmacılar Community Distributed Design DS8 için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Bakım Kullanıcı El Kitabı indirin. Community Distributed Design DS8 12 sayfaları. Distributed design series surface mount loudspeakers
Ayrıca Community Distributed Design DS8 için: Kurulum ve Kullanım Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Installation and Wiring
1. Connect incoming input wires
(and optional loop-thru wires)
from wall to four Euroblock screw
terminals concealed in the base of
the Infin-A-Ball bracket.*
*Note: Check local codes
Input Wires
to determine if a wall
(not included)
box or metal plate is re-
quired for the integrated
Loop-Thru Wires
wiring. See page 10.
(optional)
Terminal Block
Infin-A-Ball bracket
2. Secure the Infin-A-Ball bracket to the
wall using your screws or other fasteners
according to local building and safety codes.
Loosen
Tighten
3. Insert the hex wrench into the socket near
the rear of the loudspeaker cabinet, and
turn counterclockwise to loosen the clamp
setscrew.
4. Fit the cabinet onto the IAB bracket's ball-
end, then tighten the clamp sufficiently to
hold the loudspeaker in place, but allowing
for positional adjustment.
Community Distributed Design Series
Installation and Operation Manual
Page 7
Surface Mount Loudspeakers