Bosch Series 4 Kullanım Kılavuzu - Sayfa 16

Sayfayı Yazdır

Trouble shooting

Area

Cleaning product

Appliance front

Hot soapy water: Clean using a dish cloth and

then dry with a soft cloth. Do not use metal or

glass scrapers for cleaning.

Appliance front with

Hot soapy water: Clean using a dish cloth and

stainless steel

then dry with a soft cloth. Remove splashes

and patches of limescale, grease, starch and

albumin (e.g. egg white) immediately. Corro-

sion can form under these patches or

splashes. Special stainless-steel cleaning prod-

ucts are available from the after-sales service

or from specialist retailers. Do not use glass

cleaners or metal or glass scrapers for clean-

ing.

Cooking compart-

Hot soapy water or vinegar solution: Clean

ment made of stain-

using a dish cloth and then dry with a soft

less steel

cloth.Do not use oven spray or any other

aggressive oven cleaners or abrasive materi-

als. Scouring pads, rough sponges and pan

cleaners are also unsuitable. These items

scratch the surface. Allow the interior surfaces

to dry completely.

3Trouble shooting

I f a fault occurs, there is often a simple explanation.

T r o u b l e s h o o t i n g

Before calling the after-sales service, please refer to the

fault table and attempt to correct the fault yourself.

If a dish does not turn out exactly as you wanted,

Tip:

refer to the following chapter, where you will find lots of

tips and notes relating to the optimum

settings.~ "Tested for you in our cooking studio"

on page 18

Fault table

Fault

The appliance is not working

Three zeros are lit on the display.

The appliance is not operating. A

cooking time is shown on the display.

The microwave is not working.

Possible cause

The plug is not plugged into the mains

Power failure

The circuit breaker/fuse is faulty

Faulty operation

Power failure

The rotary selector has been accidentally turned.

The "start" button has not been pressed after the set-

ting was applied.

The door has not been properly closed.

The "start" button has not been pressed.

Area

Cleaning product

Recess in the cook-

Damp cloth: Water must not be allowed to run

ing compartment

into the appliance through the turntable drive.

Dry the turntable drive with a cloth.

Turntable and roller

Hot soapy water: When placing the turntable

ring

back into its recess, it must engage properly.

Wire rack

Hot soapy water: Soak and clean with a dish

cloth or brush. Do not scour.Do not use metal

or glass scrapers for cleaning.

Door panels

Glass cleaner: Clean with a dish cloth. Do not

use glass scrapers.

Warning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by

one of our trained after-sales technicians. If the

appliance is defective, unplug the appliance from the

mains or switch off the circuit breaker in the fuse box.

Contact the after-sales service.

Remedy/information

Connect the appliance to the electricity supply

Check whether other kitchen appliances are working

Check in the fuse box to make sure that the circuit

breaker/fuse for the appliance is in working order

Switch off the circuit breaker/fuse for the appliance in

the fuse box and switch it back on after approximately

10 seconds

Reset the time.

Press the "stop" button.

Press the "start" button or cancel the setting by press-

ing the "stop" button.

Check whether food remnants or debris is/are

trapped in the door.

Press the "start" button.