Bosch Series 4 Kullanım Kılavuzu - Sayfa 10

Sayfayı Yazdır

Installation and connection

Faults in the gas installation/smell of gas

If you notice a smell of gas or faults in the gas

installation, you must

immediately shut off the gas supply and/or close the

■

gas cylinder valve

immediately extinguish all naked flames and

■

cigarettes

switch off electrical appliances and lights

■

open windows and ventilate the room

■

call the aftersales service or the gas supplier

■

Moving the appliance by the gas line or door handle

Do not move the appliance while holding the gas line;

the gas pipe could be damaged. There is a risk of a gas

leak! Do not move the appliance while holding it by the

door handle. The door hinges and door handle could

be damaged.

Electrical connection

The appliance is designed to operate at 220-240 V. A

16 A fuse is required for connection.

Have the appliance installed by your after-sales service.

Any damage arising from the appliance being

connected incorrectly will invalidate the warranty.

Caution!

If the electricity supply drops below 180 V, the

■

electrical ignition system does not work.

If the supply cord is damaged, it must be replaced

■

by the manufacturer, its service agent or similarly

qualified persons in order to avoid a hazard.

Warning – Danger of death!

There is a risk of electric shock if you touch live

components.

Always make sure your hands are dry when you

■

touch or hold the mains plug.

Only pull out the mains cable by taking hold of the

■

plug and removing the plug; never pull it out by the

mains cable itself, as this could damage it.

Never unplug the mains plug when the appliance is

■

in operation.

Please note the following information and ensure that:

Notes

The mains plug fits the socket.

■

The cable cross section is adequate.

■

The earthing system is properly installed.

■

The mains cable is only replaced by a qualified

■

electrician (if this is necessary).Spare mains cables

can be ordered from our after-sales service.

No power strips/multi-way connectors or extension

■

cables are used.

If using a residual current device, only use one that

■

bears the mark

The presence of this mark is the only way to be sure

that it fulfils all the applicable regulations.

The mains plug can be accessed at all times.

■

The mains cable is not kinked, crushed, modified or

■

severed.

The mains cable does not come into contact with

■

heat sources.

For the after-sales service

Caution!

The appliance must be connected in accordance

■

with the data on the rating plate.

Only connect the appliance to an electrical

■

connection that meets the applicable provisions. The

socket must be easily accessible so that you can

disconnect the appliance from the electricity supply

if necessary.

Please ensure the availability of a multi-pin

■

disconnecting system.

Never use extension cables or multiple plugs.

■

For safety reasons, this appliance must only be

■

connected to an earthed connection. If the safety

earth terminal does not comply with regulations,

safety against electrical hazards is not guaranteed.

An all-pole isolating switch with a contact gap of at

■

least 3 mm must be present in the installation circuit.

This is not necessary if the appliance is connected

by a plug that is accessible to the user.

Electrical safety: The cooker corresponds to safety

■

class I and may only be used in conjunction with a

safety earth terminal.

You must use a H 05 W-F type cable or equivalent

■

for the appliance connection.

The mains voltage must correspond to the voltage

specified on the rating plate.

Caution!

All appliances with a three-wire cable must be

earthed.

Connect the wires in the power cord according to the

colour coding:

Explanaions

Green and yellow

earth wire

Blue

(null) neutral wire

Brown

phase (external conductor)

If the power cord is replaced

Note:

Only connect it to the appliance as shown in the

connection diagram.

Levelling the cooker

Always place the cooker directly on the floor.

The cooker has height-adjustable feet. This allows you

to raise the plinth by about 15 mm. Please observe the

special installation instructions.

Adjacent units

Any adjacent units must not be made of flammable

materials. The fronts of any adjacent units must be heat-

resistant up to at least 90 °C.

Wall fixing

To prevent the cooker from tipping over, you must fix it

to the wall using the enclosed bracket. Please observe

the installation instructions for fixing the oven to the

wall.