Bosch WTA3500 Kurulum Talimatları Kılavuzu - Sayfa 2
Kurutucu Bosch WTA3500 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Bosch WTA3500 12 sayfaları. Electric vented dryer and electric condensation dryer
Ayrıca Bosch WTA3500 için: Kullanım ve Bakım Kılavuzu (12 sayfalar), Kullanım ve Bakım Kılavuzu (13 sayfalar), Kullanım Talimatları Kılavuzu (44 sayfalar)
Sayfayı Yazdır
Introduction
Read these installation instructions completely and
carefully. They will save you time and effort and help
to ensure optimum dryer performance. Be sure to
observe all listed warnings and cautions.
These installation instructions are intended for use by
qualified installers. In addition to these instructions
the dryer shall be installed:
•
In the United States, in accordance with the
National Electric Code, ANSI/NFPA70 ~ latest
edition/State and Municipal codes and/or local
codes.
•
In Canada, in accordance with the Canadian
Electric Code C22.1 - latest edition/Provincial
and Municipal codes and/or local codes.
Tools Needed for Installation
The following tools are needed far installation of this
dryer:
•
Box cutter
•
Flat blade screwdriver
•
#2 Phillips head screwdriver
•
Duct tape
•
Caulking gun and compound
•
Level
•
Safety goggles
•
Gloves
Parts Supplied for Installation
Condensation water drain hose (WTL 5400 only)
Stacking kit
Parts Needed for Installation
(Model WTA 3500 Only!)
Four inch (approx. 100 mm) diameter metal exhaust
duct (rigid or flexible) of proper length and with
elbows and exhaust vent hood required to vent to
outdoors.
Dryer Electrical Cord
The Bosch dryer comes with a 4-wire power supply
cord pre-installed. This cord fits a 4-wire receptacle
as shown in the upper section of Figure 1.
If your receptacle is a 3-wire receptacle, as shown in
the lower section of Figure 1, a 3-wire "Dryer Cord"
must be purchased locally. The 4-wire cord must then
be removed and the 3-wire cord installed in its place,
as instructed in following section titled,
To Change Cord.
When purchasing a 3-wire power supply cord make
sure the cord meets following requirements:
•
U.L listed in the USA, CSA listed in Canada
•
240 volt rated (minimum)
•
30 ampere
•
Type SRD or SRDT
•
Five feet long (minimum)
4-wire receptacle
(14-30R)
3-wire receptacle
(10-30R)
Dryer shipped with
cord to fit this type
4-wire receptacle.
If you have 3-wire
receptacle, like this,
a 3-wire dryer cord
must be purchased
locally.
Figure 1.
Grounding Instructions
This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least
resistance for the electric current. This appliance is
equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
Improper connection
of the equipment-
grounding
conductor
can result in a risk of
electric
shock. Check with a qualified
electrician
or serviceman
if you are in
doubt as to whether the dryer is properly
grounded.