ANDERSON-NEGELE MPI-300 Kullanım Kılavuzu - Sayfa 5
Araçlar ANDERSON-NEGELE MPI-300 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ANDERSON-NEGELE MPI-300 8 sayfaları. Ncs-m parameter tool
Sayfayı YazdırOperating Manual MPI-300
Materials
Temperature ranges
Response time and delay
Electrical connection
Output
Measurement range
Weight
5
MPI-300 Programming Adapter
5.1
Installation USB Driver
1. Insert the CD accompanying the MPI-300 into the CD drive.
2. Double-click the setup f ile in the directory "MPI-300 USB" to start the installation process
f or the driver.
3. Foll ow the instructions of the installation assistant.
4. Af ter successf ul installation, the USB adapter is detected and an additional COM port
appears in the system f or communication.
5.2
Preparation of Parameter Tool
1. Insert the CD accompanying the MPI-300 into the CD drive.
2.
The executable f il e in the "Parameter Tool" directory does not require any installation and
can be copied to any location
6
NCS-M Parameter Tool
Af ter successf ul installation of the driver f or the MPI-300 programming adapter, it can be con-
nected to the computer. This is done via the USB port of the programming adapter. The sensor,
which is to be parameterized, must be connected to the programming adapter via the M12 con-
nector. The NCS-M parameter tool can then be started by double-clicking.
6.1
General Information on the User Interface
Af ter the application is started, the start screen of the graphic user interf ace appears as shown
below. Parameters of the NCS-M sensor can be changed by the customer in accordance with the
customer's applications.
Threaded connector
Coupling part
Ambient
Process
CIP / SIP
conf igurable
Cabl e connection
Suppl y voltage
Prot ect ion cl ass
NCS-M-11
NCS-M-12
.
Stainless steel 1.4305
PEEK (FDA approval: 21 CFR 177 2415)
0... 70 °C
-10... 115 °C
143 °C max. 120 min
0,1... 10 sec
M12 connector, stainless steel 1.4305
16... 32V DC
IP 69K
PNP active 50 mA (short-circuit proof )
Dk > 20
Dk > 2
100 g
5