Airtec CYPRES Kullanım Kılavuzu - Sayfa 8

Ölçüm Cihazları Airtec CYPRES için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Airtec CYPRES 17 sayfaları. Water resistant kit

Place the supplied brown strip of capton (appx. 1cm x 18cm) into the bottom

case as shown. The strip has to be placed at the edge of the control unit cable.

The capton strip must not obstruct the filter pressure entrance point (round

metal area).

Place the capton strip not in front of the filter entrance.

The capton strip makes it easier to remove the CYPRES from the housing

later.

Place the CYPRES carefully into the housing.

If the CYPRES is a 1-pin model, seal the remaining empty cutter cable routing

with the supplied rubber ("blind") stopper.

Instruction Manual CYPRES Water Resistant Kit

Place it like in the sketch above.

Airtec GmbH

page 8