Bosch WTW87F90CH Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 15
Kurutucu Bosch WTW87F90CH için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Bosch WTW87F90CH 48 sayfaları.
Ayrıca Bosch WTW87F90CH için: Kurulum ve Kullanım Talimatları Kılavuzu (32 sayfalar)
Sayfayı Yazdır
:
Warning
Risk of injury!
The appliance is very heavy. Lifting it
■
may result in injury.
Do not lift the appliance on your
own.
The appliance has sharp edges on
Ri s k of i n j u ry!
■
which you could cut your hands.
Do not take hold of the appliance by
its sharp edges. Wear protective
gloves to lift it.
Caution!
Material damage/damage to the
appliance
If the appliance overheats, it may not be
able to operate properly, or this may
result in material damage or damage to
the appliance.
Make sure that the appliance's air inlet
is never obstructed when the appliance
is in operation, and that the area around
the appliance is adequately ventilated.
Install the appliance as follows:
Place the appliance on a clean,
1.
even, solid surface.
Check that the appliance is level
2.
using a spirit level.
If necessary, turn the appliance feet
3.
to make sure it is level.
You can now connect the appliance.
Notes
All appliance feet must stand firmly
■
on the ground.
Installing and connecting the appliance
If appliances are not installed
■
correctly, this may result in noises,
vibrations, uneven drum operation
and/or to residual water leaking out
of the appliance.
Connecting the appliance
:
Warning
Risk of electric shock/fire/material
damage/damage to the appliance!
If the appliance is not installed properly,
this may lead to a dangerous situation.
Ensure the following:
The mains voltage on your power
■
socket must match the rated voltage
specified on the appliance
(identification plate). The connected
loads and the required fuse
protection are specified on the
identification plate.
The appliance must only be
■
connected to alternating voltage via
a protective contact socket that has
been correctly installed. This plug
socket must be freely accessible at
all times.
The mains plug and the protective
■
contact socket must match and the
earthing system must be correctly
installed.
The installation must have an
■
adequate cross section.
The mains plug must be freely
■
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(all pole disconnection) must be built
into the permanent installation in
accordance with electrical
installation regulations.
If using a residual current circuit
■
breaker, only use one that bears the
following mark: z. The presence of
this mark is the only way to be sure
that it fulfils all the applicable
regulations.
en
15