Bosch WTY877W0AU Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 14
Kurutucu Bosch WTY877W0AU için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Bosch WTY877W0AU 44 sayfaları.
Sayfayı Yazdır
Installation and connection
en
During installation, ensure that:
The dryer is placed on a clean, level
■
and firm surface,
The mains plug can be accessed at
■
all times,
The area around the dryer is kept
■
clean and
The dryer is levelled using the
■
threaded feet.
Check the alignment of the
Note:
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
If in doubt, have the appliance
Note:
connected by a specialist.
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
Set the programme selector to the
1.
"Off" position, disconnect the dryer
from the mains and open the door.
14
Remove the screws from the dryer
2.
and then remove the dryer door.
Use a T20 (Torx) screwdriver
Note:
only. Do not use any other tools to
change the side on which the door is
hinged.
Carefully place the dryer door onto a
3.
flat surface, and place a hand towel
or other such item between the door
and the surface to avoid scratching
or damaging the door.
Now remove the screws from the
4.
door hinge, and remove the hinge
from the dryer door.