Comnet netwave NWKED Hızlı Başlangıç Kılavuzu - Sayfa 3

Verici Comnet netwave NWKED için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Comnet netwave NWKED 5 sayfaları. Video encoder/decoder kit for use with netwave wireless ethernet

Sayfayı Yazdır
QUICK START USER GUIDE
FIGURE 3 – INSTALLATION INSTRUCTIONS
Step 1.
Unpack the hardware from the box. Instructions for the Decoder and the Encoder are the same.
D
B
A
C
E
E
TECH SUPPORT: 1.888.678.9427
Step 2.
A. Connect the Power Adapter with the Terminal Block
B. Connect the Terminal Block to the power port on the device
Step 3.
Connect the video source to BNC Port on the Encoder.
Press and twist the BNC connector to ensure a secure fit.
Connect the Coaxial cable from the receiver to the composite port
on the Decoder. Press and twist the BNC connector to ensure a
secure fit.
Step 4.
A. Connect one end of an RJ-45 Ethernet cable to the OUT port
B. Connect the RJ-45 Ethernet cable attached to the PIM to the
C. Connect the power adaptor to the main electrical supply and
D. Connect the RJ-45 cable from Port 2 on the access point to
E. A Drip Loop is recommended as additional precaution
E
of the Power Injection Module (PIM) and the other end to LAN
of the access point.
Maximum length of the RJ-45 CAT5 cable is 100 meters.
Encoder/Decoder.
the power plug into the socket of the PIM.
PoE power input: Passive PoE (range 12 to 24 VDC)
an external PoE device, typically a camera as shown.
against moisture.
NWKED
INS_NWKED_QS_REV– 05/20/13 PAGE 3