ATK 260LQ 1995 Kullanıcı El Kitabı - Sayfa 17

Motosiklet ATK 260LQ 1995 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. ATK 260LQ 1995 18 sayfaları.

Brake pads:

Air ﬁlter:

The brake pad's thickness should be

checked after each ride. The pads

should be replaced when they are 1/8

inch thick. The front and rear brake

pads are identical.

Ignition:

The SEM ignition is preset at 2.05mm

BTDC at the factory and should

require no further adjustment.

The air ﬁlter should be cleaned in sol

vent after every ride and re-oiled. To

perform this maintenance, remove the

seat, then loosen the hose clamp on

the back of the carburetor and pull the

air ﬁlter from the airbox. Regular

engine oil or special foam air ﬁlter oil

may be used to oil the ﬁlter. Before

installing the air ﬁlter into the airbox,

clean the inside of the airbox and

apply heavy waterproof grease to the

front of the sealing ﬂange on the air ﬁl

ter carrier. Then reinstall the ﬁlter,

pushing the sealing ﬂange tightly

against the front of the airbox while

tightening the ﬁlter carrier hose clamp

to the back of the carburetor.

1 5

ATK 1995 Owner's Manual