Comnet FVT1021 series Kurulum Talimatları

Alıcı Comnet FVT1021 series için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Comnet FVT1021 series 4 sayfaları. 10-bit video receiver with return data

Sayfayı Yazdır

Mechanical Installation Instructions

Figure 1– Dimensions are for a standard ComNet

Rack Module:

The unit is designed to be installed in the ComNet 19-inch (483-mm) EIA standard card-cage rack, the C1-US,

C1-EU, or the C1-CH. Follow these guidelines to install rack cards after performing module setup procedures.

C1-US, C1-EU, or the C1-CH Card Cage Racks

CAUTION: Although the units are hot-swappable and may be installed without turning power off to the rack, ComNet

recommends that the power supply be turned off and that the rack power supply is disconnected from any power

source. Note: Remove electrical connector before installing in card cage rack.

1. Make sure that the card is oriented right side up, and slide it into the card guides in the rack until the edge

connector at the back of the card seats in the corresponding slot in the rack's connector panel. Seating may

require thumb pressure on the top and bottom of the card's front panel.

CAUTION: Take care not to press on any of the LEDs.

2. Tighten the two thumb screws on the card until the front panel of the card is seated against the front of the rack.

For Technical Support, Contact Your Nearest Communication Networks Office:

3 Corporate Drive • Danbury, CT 06810 • USA • Tel: 203-796-5300 • Toll Free: 1-888-678-9427 • www.comnet.net

8 Turnberry Park Road • Gildersome • Morley • Leeds, UK LS27 7LE • Tel: +44 (0)113 307 6400 • Fax: +44 (0)113 253 7462

one slot module.

™

.156 [3.96 mm]

.313 [7.95 mm]

FVT/FVR1021

Installation Considerations

This fiber-optic link is supplied as a

Standalone/Rack module. Units should be

installed in dry locations protected from

extremes of temperature and humidity.

Standalone Module:

The unit is provided with a mounting

plate with holes for two No. 6 pan head

screws (3-mm or 3.55-mm).

Attach the module to a solid piece of

wood using two No. 6 pan head wood

screws with a minimum penetration

into the wood of 3/4 inch. (Screws not

supplied) See figure 1.

1. Determine where the module will

be installed, and ensure that there

is adequate space at both ends for

making the various cable connections

and for reading the diagnostic LEDs.

2. Attach the module to a flat surface

using two mounting screws.

INS_FVT/FVR1021_REV–

07/28/09

Page 1