Electrolux EGG 690 Talimat Kitapçığı - Sayfa 11

Hob Electrolux EGG 690 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Electrolux EGG 690 16 sayfaları. Electrolux gas hob instructions egg 690

Sayfayı Yazdır

Wiring Diagram

Brown

Fault Finding

Preliminary Electrical Systems

Check

Blue

Green

Yellow

Blue

Green

Brown

Yellow

220

240

START

Isolate appliance

and carry out:

A: Earth Continuity

check.

YES

Carry out:

C: Polarity check.

Has inlet fuse blown?

YES

Inlet wiring

faulty.

Rectify any

fault.

Isolate appliance and

carry out:

B: Insulation check.

Rectify any fault

including replacing

fuses as necessary.

A. IGNITOR SWITCH

B. IGNITOR UNIT

PLUG (with cover

removed)

( )

Earth Wire

Green/Yellow

Neutral Wire

Blue

Carry out:

D: Resistance to

Earth check.

A. EARTH CONTINUITY CHECK - Appliance must be

electrically disconnected - meter set on Ω (Ohms) x

1 scale and adjust zero if necessary.

a) Test leads from any appliance earth point to earth

pin on plug. Resistance should be less than 0.1

Ω (Ohm), check all earth wires for continuity and

all contacts are clean and tight.

B. INSULATION CHECK - Appliance electrically

disconnected, all switches ON.

a) meter set on Ω (Ohms) x 1 scale.

Test leads from L to N in appliance terminal block.

If meter reads «0» then there is a short circuit.

b) meter set on Ω (Ohm) x 100 scale.

Repeat test with leads from L to E. If meter reads

less than ∞ (infinity) there is a fault.

NOTE - Should it be found that the fuse has failed

but no fault is indicated - a detailed continuity check

(i.e. by disconnecting and checking each

component) is required to trace the faulty component.

It is possible that a fault could occur as a result of

local burning/arcing but no fault could be found under

test. However a detailed visual inspection should

reveal evidence of burning around the fault.

SOCKET

(face view)

( )

Electricity supply

should now be

satisfactory.