Dremefa Bobike Junior Kullanım Talimatları Kılavuzu - Sayfa 8

Bisiklet Aksesuarları Dremefa Bobike Junior için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Dremefa Bobike Junior 14 sayfaları.

Sayfayı Yazdır

General

Congratulations on purchasing the Bobike junior, the safe and

comfortable bicycle child seat from the Bobob line. Read these

instructions for assembly and use carefully before assembling the seat.

Store these instructions in a safe place for future reference.

• The Bobike is suitable for the transportation of children in the age

category 5 to 10 years old. The maximum permitted weight is 32 kg.

• The seat is not intended for use on mopeds. Consult your supplier

if you have any questions regarding the assembly or use of the

Bobike junior.

• Use the Bobike maxi assembly set to assemble the Bobike junior.

These sets can also be purchased separately.

• When reusing the insert, it may be necessary to raise the saddle

slightly so that the Bobike junior will fit properly.

Assembly

• Attach the plug-in element (H) to the upright rear fork under the

saddle – the counter element is tightened with spanner 13 (with

the flat side facing the rear fork). Ensure that the plug-in element

is mounted horizontally and with the T-shaped opening in the

correct position (wide slot on top) (fig. 5).

• Attach both mounting studs (C) approximately 30 cm under the

plug-in element (H) perpendicular to the rear fork (fig. 1). The

mounting studs are suitable for rear forks with a ø of 12 to 25 mm

(fig. 2). To adjust, insert the clamping bracket in the front, middle

or rear slot.

• Ensure that the elements on both the left and right are mounted at

exactly the same height. Screw the bolt hand-tight with the Allen key

and completely unscrew the stud on the assembly stud.

• Now take the seat and insert the head of the mounting bracket (G)

straight and completely into the plug-in element (fig. 5).

• Turn the footrest bar (B) to the correct position, place the ends in

the assembly studs (C) and screw the studs tight.

• Adjustment. The seating surface of the Bobike junior must slope

gently to the rear. Ensure that there is a sufficient gap between the

seat and the baggage holder or mudguard. To improve the position

of the seat, move the assembly studs (C) up or down. When the

correct position has been achieved, screw the assembly stud bolt

tight.

• Foot support (D) height adjustment. You can set the foot rest at 4

heights by screwing the Allen bolts into the lowest and top holes of

the washer plate (fig. 3).

• Safety regulations: After assembling the Bobike junior check that

the gap between the back of the child safety seat and the rear axle

is no more than 30 cm before using the seat with your child (fig. 4).

• Put your child into the Bobike junior and check that the chosen

setting is correct. Always take the child out of the seat before

changing the setting.

ENGLISH