Electrolux EGL6282NOX Kullanıcı Kılavuzu - Sayfa 8

Hob Electrolux EGL6282NOX için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux EGL6282NOX 20 sayfaları.

Sayfayı Yazdır

www.electrolux.com

4.1 Burner overview

A) Burner cap

B) Burner crown

C) Ignition candle

D) Thermocouple

4.2 Ignition of the burner

Always light the burner

before you put on the

cookware.

WARNING!

Be very careful when you

use open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Push the control knob down and turn

it counterclockwise to the maximum

gas supply position (

2. Keep the control knob pushed for

equal or less than 10 seconds. This

lets the thermocouple warm up. If

not, the gas supply is interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner

does not light, check if the

crown and its cap are in

correct positions.

4.3 Turning the burner off

To put the flame out, turn the knob to the

off position

4.4 Before first use

Put a cookware containing water on each

electric cooking zone, set the maximum

position and operate the hob for 10 min.

This is to burn off the residue in the

appliance. After that, operate the hob at

minimum position for 20 min. During this

WARNING!

Do not keep the control knob

pushed for more than 15

seconds. If the burner does

not light after 15 seconds,

release the control knob,

turn it into off position and try

to light the burner again after

minimum 1 minute.

CAUTION!

In the absence of electricity

you can ignite the burner

without electrical device; in

this case approach the

burner with a flame, turn the

control knob counter-

clockwise to maximum gas

supply position and push it

down. Keep the control knob

pushed for equal or less

than 10 seconds to let the

thermocouple warm up.

If the burner accidentally

goes out, turn the control

knob to the off position and

try to light the burner again

after minimum 1 minute.

The spark generator can

start automatically when you

switch on the mains, after

installation or a power cut. It

is normal.

WARNING!

Always turn the flame down

or switch it off before you

remove the pans from the

burner.