Electrolux EHB30100 Kullanıcı Kılavuzu - Sayfa 4

Hob Electrolux EHB30100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux EHB30100 12 sayfaları. Electrolux hob

Sayfayı Yazdır

4 electrolux

fuses removed from the holder), ground

leakage trips and contactors.

The manufacturer is not responsible for

any injury to persons and pets or dam-

age to property caused by failure to

obey these requirements.

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the lo-

cal power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a correct

plug, able to support the load marked on

the rating plate. The plug has to be fitted

in a correct socket.

• Any electrical component must be instal-

led or replaced by the Service Force

Centre technician or qualified service per-

sonnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains

plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in conform-

ity with the standard and regulations

force.

• The power cable must be placed in such

a way that it does not touch any hot part.

• Connect the appliance to the mains with

a device that lets to disconnect the appli-

ance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90 °C. The

blue neutral cable must be connected to

the terminal block label with "N". The

brown (or black) phase cable (fitted in the

terminal block contact marked with "L")

must always be connected to the live

phase.

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

Assembly

min. 650 mm

If several 30 cm hobs are to be installed

side by side into the same cut out, an as-

sembly kit including a support side bracket

and supplementary seals is available at our

Service Centres. The relevant installation in-

structions are supplied within the kit pack-

age.

A — supplied seal

B — supplied brackets

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be

easy to remove and let an easy access in

case a technical assistance intervention is

necessary.

490 mm

270 mm