Andon KD-5904 Kullanım Kılavuzu - Sayfa 9

Kan Basıncı Monitörü Andon KD-5904 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Andon KD-5904 19 sayfaları.

DN:KD-5904-SMSY01 V3.0
Avoid compression or restriction of the connection tubing during measurement,
which may cause inflation error, or harmful injury due to continuous cuff
6.

APPLYING THE CUFF

a. Pulling the cuff end
packaged like this already), turn it outward (away from your
body) and tighten it and close the Velcro fastener.
b. Place the cuff around a bare arm 1-2cm above the elbow joint.
c. While seated, place palm upside in front of you on a flat surface
such as a desk or table. Position the air tube in the middle of
your arm in line with your middle finger.
d. The cuff should fit comfortably, yet snugly around your arm.
You should be able to insert one finger between your arm and the cuff.
Note:
Please refer to the cuff circumference range in "SPECIFICATIONS" to make
1.
sure that the appropriate cuff is used.
2.
Measuring on same arm each time.
3.
Do not move your arm, body, or the monitor and do not move the rubber tube
during measurement.
4.
Stay quite, calm for 5 minutes before blood pressure measurement.
5.
Please keep the cuff clean.If the cuff becomes dirty, remove it from the monitor
and clear it by hand in a mild detergent, then rinse it thoroughly in cold water.
Never dry the cuff in clothes dryer or iron it. Clean the cuff after the usage of
every 200 times is recommended.

7. BODY POSTURE DURING MEASUREMENT

Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor, and don't cross your
legs.
b. Place palm upside in front of you on a flat surface such as a
desk or table
c.
The middle of the cuff should be at the level of the right atrium of the heart.
Lying Down Measurement
a. Lie on your back.
b. Place your arm straight along your side with your palm
upside.
c.
The cuff should be placed at the same level as your
heart.
through the medal loop (the cuff is
9/19
Operation Guide
pressure.
JS-KD5904-03-V2.0