Electrolux EHD30010P Kullanıcı Kılavuzu - Sayfa 10
Hob Electrolux EHD30010P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux EHD30010P 12 sayfaları. Ceramic glass induction hob
Ayrıca Electrolux EHD30010P için: Şartname (18 sayfalar)
Sayfayı Yazdır
10 electrolux
Removing the dirt:
1. – Remove immediately: melting plas-
tic, plastic foil, and food containing
sugar. Use a special glass ceramic
scraper. Put the scraper on the glass
ceramic surface at an acute angle and
slide the blade on the surface.
– Stop the appliance and let it cool
down before you clean: limescale
What to do if...
Problem
You cannot start the appliance or
operate it.
A sound operates when the ap-
pliance is off.
The residual heat indicator does
not come on.
Heat setting alternates
A sound operates and appliance
starts and stops again. After 5
seconds one more sound oper-
ates.
comes on
comes on
and number come on.
come on
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
2. Clean the appliance with a damp cloth
and some detergent.
3. At the end rub the appliance dry with
a clean cloth.
Possible cause and remedy
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the control
panel
• The child safety device or key lock or
chapter Operating the appliance.
• Start the appliance again and set the heat setting in 10 seconds.
You covered one or more sensor fields. Uncover the sensor fields.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone is supposed to be hot, speak to the After
Sales Service.
The Power management is active. See the section Power man-
agement.
You covered
. Uncover the sensor field.
• The automatic switch-off operates. Stop the appliance and start
it again.
Overheating protection for the cooking zone operates. Switch off
the cooking zone. Switch on the cooking zone again.
• No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the
cooking zone. Move cookware to a smaller cooking zone.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time.
Disconnect the fuse from the electrical system of the house. Con-
nect again. If
comes on again, speak to the after sales service.
There is an error in the appliance, because a cookware boils dry
or you use not correct cookware. Overheating protection for the
cooking zone operates. The automatic switch-off operates.
Switch off the appliance. Remove the hot cookware. After approx-
imately 30 seconds switch on the cooking zone again.
disappear, residual heat indicator can stay. Cool down the cook-
ware and check it with the section Cookware for the induction
cooking zone.
the Customer Care Department. Give the da-
ta from the rating plate, three-digit-letter
rings, water rings, fat stains, shiny met-
allic discolorations. Use a special
cleaner for glass ceramic or stainless
steel.
operates. See the
should