Electrolux EHD60100P Kullanıcı Kılavuzu - Sayfa 10
Hob Electrolux EHD60100P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux EHD60100P 12 sayfaları. Ceramic glass induction hob
Ayrıca Electrolux EHD60100P için: Şartname (18 sayfalar)
Sayfayı Yazdır
10 electrolux
For your safety, do not clean the appli-
ance with steam blasters or high-pres-
sure cleaners.
Scratches or dark stains on the glass
ceramic have no effect on how the ap-
pliance operates.
Removing the dirt:
1. – Remove immediately: melting plas-
tic, plastic foil, and food containing
sugar. Use a special glass ceramic
scraper. Put the scraper on the glass
What to do if...
Problem
You cannot start the appliance or
operate it.
A sound operates when the ap-
pliance is off.
A sound operates 6 times, the
appliance stops.
The residual heat indicator does
not come on.
The automatic warm up function
does not start.
A sound operates and appliance
starts and stops again. After 5
seconds one more sound oper-
ates.
Sensor fields become hot.
The display changes between
two heat settings.
comes on.
– Stop the appliance and let it cool
2. Clean the appliance with a damp cloth
and some detergent.
3. At the end rub the appliance dry with
a clean cloth.
Possible cause and remedy
• The key lock or child safety device operates
tion. See the section "Locking/unlocking the control panel" and
"Child safety device".
• STOP+GO operates
"Stop and go".
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the control
panel
• Start the appliance again and set the heat setting within 10 sec-
onds.
You covered one or more sensor fields. Uncover the sensor fields.
You covered one or more sensor fields. Uncover the sensor fields.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone must be hot, speak to the after sales
service.
• There is still residual heat on the cooking zone
cooking zone cool down
• The highest heat setting is set. The highest heat setting has the
same power as the automatic warm up function.
You covered
. Uncover the sensor field.
The cookware is too big or you put it too near the controls. Put
large cookware on the rear cooking zones if necessary.
Power Management decreases the power of this cooking zone.
Use cooking zones on the other side.
• The automatic switch-off operates. Stop the appliance and start
it again.
Overheating protection for the cooking zone operates. Stop the
cooking zone and start it again.
ceramic surface at an acute angle and
slide the blade on the surface.
down before you clean: limescale
rings, water rings, fat stains, shiny met-
allic discolorations. Use a special
cleaner for glass ceramic or stainless
steel.
. Stop the function. See the section
. Stop the func-
. Let the