Atlanta ATH-401 Kullanım Kılavuzu - Sayfa 5
Demir Atlanta ATH-401 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Atlanta ATH-401 17 sayfaları. Electric iron
Sayfayı Yazdır4. As soon as the heat indicator (I) goes off, the iron is heated to the required
temperature and you can start ironing.
5. Do not let the soleplate come in contact with hard objects (buttons, fasteners
and so on).
6. After you have finished ironing, unplug the iron and place it in the vertical position
to cool down.
NOTES
•
Do not heat the iron on a gas or electric cooker.
•
When first in use you may notice a characteristic odour of burnt tool lubricant.
•
If you've been ironing with the heat regulator (D) set for '
to set it for '
' or ' ', the iron temperature will go down to the adequate level
after some time, but not at once! If you want to make sure the iron temperature
corresponds to the selected level, unplug the iron and let it cool down, then plug it
again.
•
The manufacturer has the right to make alterations in the iron design to improve
the consumer properties of the unit.
SAFETY MEASURES
•
The iron is adjusted to function with the power supply specified on the label.
•
Never operate the iron on uneven surface that is not heat-resistant.
•
This appliance is not intended for use by children or persons with reduced
physical, sensory or mental capabilities, or wanting in knowledge or experience,
unless they are given supervision by a person responsible for their safety.
•
If the power supply cord is damaged, it should be replaced by the manufacturer
or its agent, or the responsible qualified person.
•
Close supervision is necessary when the appliance is used around children.
Never leave the appliance unattended when in use. Do not let the power supply
cord hang from the table, because children can bring the iron down by it and suffer
serious burns.
•
Be careful: do not touch the iron soleplate when in use. Do not operate the
appliance close to objects that can be easily deformed by high temperature.
•
Put the iron in a vertical position only.
•
In order to reduce the risk of fire and electric shock:
- do not use this appliance in damp rooms;
- do not plug the appliance if there is water on its surface;
- do not plug or unplug the appliance with wet hands;
- do not allow the plug to overheat; make sure the appliance is properly plugged;
- do not use the iron if the supply cord is damaged or wet;
INSTRUCTION MANUAL
5
', and then decided