andover SPINSTAND Montaj Kılavuzu - Sayfa 5

Raflar ve Standlar andover SPINSTAND için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. andover SPINSTAND 11 sayfaları. Component & record rack

Sayfayı Yazdır
Assembly
1.
Locate the Top Shelf (Item 1) and place
it
top-down on a soft surface. The holes
in
the corners of the shelf are closer to the back edge than to the front edge. Orient the
top shelf so that the wider border (Front) is towards
you.
2.
Install the Headphone Hanger (Item 13) using the two screws
(Item 14).
Align the
Headphone hanger with the pilot holes corresponding to the side of the stand you
prefer to hang your
headphones.
You may omit this step if you don't need the hanger.
3.
Install one of the Anti-Tip brackets (Item 20) to the Top Shelf using two of the Short
Screws (Item 21
).
The Bracket may be shipped with the Strap (Item 24)
attached.
Press the small tab near the latch to release the strap from the bracket.
4. Place a panel nut (Item 7) in each
of the four corners facing upwards
as shown in the diagram.
5. Attach a Threaded Rod onto each
of the four Panel Nuts and tight-
en firmly using the Allen Wrench
supplied (Item 19). For the typical
4-shelf assembly, use the Short
Rods (Item 15). If you prefer the
3-shelf option, use the Medium
Rods (Item 16), and proceed di-
rectly to Step 9.
6.
Attach a Coupler (Item 8) to each of
the four Threaded Rods.
7. Attach a Medium Rod (Item 16) to
each of the couplers. Tighten firmly
by hand.
8.
Slide a Short Pillar (Item 5) over
each rod assembly and carefully
align the pillar in the square recess
cut in the
shelf.
9. Slide the Upper Shelf (Item 2)over
the threaded rods making sure
the edge with the wider spacing
between the holes and the edge is
towards the front, just as you did
with the Top
Shelf.
Wider Space
towards front
\
Page6
Right
side
Left
side
Headphone Hanger
Headphone
Hanger