Dremel VersaFlame 2200-01 Kullanım/Güvenlik Talimatları Kılavuzu - Sayfa 8
El feneri Dremel VersaFlame 2200-01 için çevrimiçi göz atın veya pdf Kullanım/Güvenlik Talimatları Kılavuzu indirin. Dremel VersaFlame 2200-01 10 sayfaları.
Sayfayı Yazdır
g. Once the torch is ignited you can hold on
to the Ignition Button to maintain the flame,
or slide the Lock Button to the lock position
for continuous operation.
To turn off the Dremel VersaFlame, move the
Lock-On Button to the left, if it was engaged
during use, and let go of the Ignition Button
as shown in Figure 11. This will immediately
stop the flow of butane gas.
the unlocked position. Pressing and
releasing the ignition button will not
extinguish the torch if the lock on button was
moved to the lock on position during use.
Adjustment of the flame length / temperature
can be made by adjusting the Flame Control
Slider as shown in Figure 12. To increase
flame length and temperature move the
Flame Control Slider to the right. To
decrease flame length and temperature
move the Flame Control Slider to the left.
When using the Soldering Tip allow 25
seconds for the tip to reach full temperature.
When using only the Flame Diffuser, Blower,
or Deflector, the full temperature is available
immediately after ignition.
Find Quality Products Online at:
To extinguish torch the
W RNING
lock-on button must be in
Flame Length and Temperature
Adjustment
GlobalTestSupply
www.
FIG. 12
-8-
.com
FIG. 11
+