Electrolux 42 Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 32
Havalandırma Davlumbazı Electrolux 42 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Electrolux 42 45 sayfaları. 30” and 36” free-standing range hood
Ayrıca Electrolux 42 için: Kurulum, Kullanım ve Bakım Kılavuzu (22 sayfalar)
Sayfayı Yazdır
8 SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for
anti-tip security.
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Drive a screw through the trim and into the
adjacent cabinet using holes provided.
• Follow the same procedure on the opposite
side.
Raise Grille Panel
to Stop Position
Drive Screws
Through Case Trim Into
Adjacent Cabinets
9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door
stop. When space does not allow the door to
swing open fully to 130°, you may change the
door swing to a 90° opening.
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION.
• Open the door to view the bottom hinge.
Note the door stop pin location. The pin is
factory installed in the 130° position.
• Partially close the door. From above, use a
flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90° position.
Interior
90°
130°
Hinge
Installation Instructions
Door
32
10 INSTALL GRILLE PANEL
• Raise the grille panel to the stop position.
Raise
Grille
Panel
• Remove 4 screws on bottom trim; retain
all screws.
• Remove bottom trim.
• NOTE: Stainless steel and acrylic panels
are covered with a protective film. Remove
the film before installing the panel.
• Slide panel over the metal backer panel
and under the trim.
• If necessary, tap with a wood block until
panel slips under the top trim piece.
• Reassemble bottom trim. Tighten screws.