Electrolux CH 710X Talimat Kitabı - Sayfa 14

Havalandırma Davlumbazı Electrolux CH 710X için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Electrolux CH 710X 21 sayfaları. Electrolux cooker hood instruction book

Sayfayı Yazdır

Fitting the Wall Brackets

Wall marking:

• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area

in which the hood will be installed.

• Draw a horizontal line at 650 mm above the hob.

• Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre

(notch) with the vertical reference line.

• Mark the wall at the centres of the holes in the bracket.

• Place bracket 7.2.1 on the wall as shown at X mm below the ﬁ rst bracket (X = height of the upper chimney

section supplied), aligning the centre (notch) with the vertical line.

• Mark the wall at the centres of the holes in the bracket.

• Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal

reference line.

• Repeat this operation on the other side.

• Drill ø 8 mm holes at all the centre points marked.

• Insert the wall plugs (not supplied) in the holes.

• Fix the lower bracket 7.2.1 using the two screws (not supplied).

• Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the two screws (not sup-

plied).

• Insert the two screws (not supplied) supplied in the hood body ﬁ xing holes, leaving a gap of 5-6 mm between

the wall and the head of the screw.

Note: If the hood is to be installed onto a hollow construction or plaster or partition board wall then special

ﬁ xing screws will be required (not supplied).

INSTALLING THE COOKER HOOD