Andrew Collinge TWIRL AND CURL AC8TC Talimatlar ve Garanti - Sayfa 5

Şekillendirici Ütü Andrew Collinge TWIRL AND CURL AC8TC için çevrimiçi göz atın veya pdf Talimatlar ve Garanti indirin. Andrew Collinge TWIRL AND CURL AC8TC 10 sayfaları. Spiral curling iron

Sayfayı Yazdır

INSTRUCTIONS

FOR USE

DUAL VOLTAGE

This appliance utilizes a positive

temperature coefficient (PTC)

heating element and operates over

a range of voltages.

Confirm the voltage available at

each location before using the

appliance.

For connection to a 240-volt supply

or above, use an attachment plug

adaptor (not included) of the

proper configuration for the power

supply receptacle.

USING THE RESERVOIR

Fill the Reservoir with water before

using the Iron

Caution: The Reservoir Plug area is

very hot immediately after use.

Let it cool down before filling.

To Fill:

1. Turn the Reservoir

counterclockwise while pushing

it into the Iron, separating it

from the rest of the unit.

Refer to Diagram C.

2. Remove the Reservoir Plug from

the Reservoir by turning and

pulling out. Refer to Diagram B.

3. Dampen the felt on the inside of

the cap with tap water for

5 - 6 seconds. Be sure to

dampen the felt of the cap

thoroughly before use. Steam

will not flow out well if the

felt is dry.

4. Fill the Reservoir with tap water.

Do not use any water other than

tap or distilled water, otherwise

malfunctioning may result.

Wipe off any spilled water

before attaching the Reservoir.

5. Insert the Reservoir Plug back

into the Reservoir. Align the Plug

Tabs between the Reservoir

Slots. Push down, twist and

secure into place.

Refer to Diagram B.

6. Replace the Reservoir inside the

top of the Iron. ALign the

Reservoir Tabs with the slots

inside the Iron. Push down and

trun clockwise until it stops.

Refer to the reverse of

Diagram C.

HEATING THE IRON

1. Insert the plug into a an AC

electrical outlet.

2. Slide the Power Switch to ON

indicated by the "1".

3. When the Heat-Ready Dot

changes from red to black, the

Iron is ready to use. It will take

approximately three minutes for

the Heat-Ready Dot to change.

Diagram C