Electrolux DVK5511BR Kullanım Kılavuzu - Sayfa 27

Havalandırma Davlumbazı Electrolux DVK5511BR için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Electrolux DVK5511BR 36 sayfaları.

Sayfayı Yazdır

1-2. RECOMMENDATIONS AND SUGGESTIONS

INSTALLATION

• The Instructions for Use apply

to several versions of this appli-

ance. Accordingly, you may find

descriptions of individual features

that do not apply to your specific

appliance.

• The manufacturer will not be held

liable for any damages resulting

from incorrect or improper instal-

lation.

• The minimum safety distance

between the cooker top and the

extractor hood is 650 mm (some

models can be installed at a lower

height, please refer to the para-

graphs on working dimensions

and installation).

• Check that the mains voltage

corresponds to that indicated on

the rating plate fixed to the inside

of the hood.

• For Class I appliances, check

that the domestic power supply

guarantees adequate earthing.

Connect the extractor to the

exhaust flue through a pipe of

minimum diameter 120 mm. The

route of the flue must be as short

as possible.

• Do not connect the extractor

hood to exhaust ducts carrying

combustion fumes (boilers, fire-

places, etc.).

• If the extractor is used in conjunc-

tion with non-electrical appliances

(e.g. gas burning appliances),

a sufficient degree of aeration

must be guaranteed in the room

in order to prevent the backflow

of exhaust gas. The kitchen must

have an opening communicating

directly with the open air in order

to guarantee the entry of clean air.

When the cooker hood is used

in conjunction with appliances

supplied with energy other than

electric, the negative pressure in

the room must not exceed 0,04

mbar to prevent fumes being

drawn back into the room by the

cooker hood.

• In the event of damage to the

power cable, it must be replaced

by the manufacturer or by the

technical service department, in

order to prevent any risks.

• If the instructions for installation

for the gas hob specify a greater

distance specified above, this has

to be taken into account. Regu-

lations concerning the discharge

of air have to be fulfilled.

• Use only screws and small parts

in support of the hood.

Warning: Failure to install the

screws or fixing device in accord-

ance with these instructions may

result in electrical hazards.

• Connect the hood to the mains

through a two-pole switch having

a contact gap of at least 3 mm.

USE

• The extractor hood has been

designed exclusively for domestic

use to eliminate kitchen smells.

• Never use the hood for purposes