Andrew Harris Woodwork Chest of Drawers Plans Montaj Talimatları Kılavuzu - Sayfa 14
İç Mekan Mobilyaları Andrew Harris Woodwork Chest of Drawers Plans için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Andrew Harris Woodwork Chest of Drawers Plans 15 sayfaları.
Sayfayı YazdırStep 12 – Fit the back panels
Fit the two back panels from the inside. I suggest you leave at least half an inch gap around the edge
and use ¾ inch finishing nails to fix it. Dimensions given in plan allow for 1 inch overlap around each
side. Make sure the back panel does not cover and allows access to the pocket hole screws that will be
used for fixing the top.
Step 13 – Fit the top
Drill pocket holes on the side and back panels facing upward for screwing the first top layer to with 1 ¼
inch pocket hole screws.
Drill through the top of the front 1 by 2 rail so the top can be screwed on from underneath.
On the front edge drill holes through the first layer of top and then screw through the first top layer into
the rail with 1 ¼ inch wood screws through the top. The screws will be hidden by the top layer of the
top.
Place the top with the good side down and then place the upturned cabinet on top. Make sure you have
equal gap all around and then fix the sides and back with 1 ¼ inch pocket hole screws and the front edge
with 2 inch wood screws through the front rail.
Step 14 – Finish
Sand well to smooth our joints and remove any wood glue residue.
Apply Pre stain and your choice of color or paint as desired. The example below was finished in Minwax
Classic Gray and Satin Poly.
www.andrewharriswoodwork.com
Page 14 of 15