Electrolux E:Line ERCE90AS Kurulum ve Kullanım Kılavuzu - Sayfa 7

Havalandırma Davlumbazı Electrolux E:Line ERCE90AS için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Electrolux E:Line ERCE90AS 10 sayfaları.

Sayfayı Yazdır

Maintenance and cleaning

caution

• Before maintenance or cleaning is carried out,

the canopy rangehood should be disconnected

from the main power supply. Ensure that the

rangehood is switched off at the wall socket

and the plug removed.

• External surfaces are susceptible to scratches and

abrasions, so please follow the instructions below

to ensure the best possible result is achieved

without damage.

Stainless Steel Surface

Clean stainless steel surfaces using non-abrasive cleaning

products that are specifically for use on stainless steel.

To ensure best results also use an even pressure and follow

the grain of the stainless steel. Use of a soft cloth reduces

the risk of scratching. If the cloth is wet ensure that a dry

soft cloth is used to wipe down the surface again reducing

the risk of any surface rust appearing.

Glass Surface

The inlay glass panel can be cleaned using warm soapy

water. Ensure the cloth is well wrung before cleaning. Use

a dry soft cloth to remove any excess moisture left after

cleaning.

Cleaning grease filters

The mesh filters can be cleaned either by hand or in

the dishwasher. After cleaning ensure that the filters are

completely dry before refitting.

By hand: Soak in warm water and some washing up liquid.

For stubborn grease stains use a soft nylon brush to help

remove these stains.

In a dishwasher: Ensure that placement of filters is made so

as to no impede the functioning of the spray arm. Washing

the filters in a dishwasher may cause discolouration of the

filters although it will not affect their performance.

electrolux e:line rangehood maintenance and cleaning/changing the halogen lamps 5

Changing the halogen lamps

Using a small flat blade screwdriver remove the inner

stainless steel ring to obtain access to the halogen globe.

When removing the inner ring, do so carefully, as the glass

lens could easily fall out of the inner ring. Remove halogen

globe, whilst cool, and replace carefully with a new globe.

The rangehood takes 2 x 20W, 12 volt halogen globes.

important

When handling globes hold with a cloth or gloves to ensure

perspiration does not come in contact with the globe as this

can reduce the life of the globe.