Atlantic PGPLG-74044 Ürün Kılavuzu - Sayfa 3
Çim ve Bahçe Ekipmanları Atlantic PGPLG-74044 için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Atlantic PGPLG-74044 12 sayfaları.
Sayfayı YazdırStep 5:
Connect one tie-down to each of the four
fiberglass poles. The tie-downs should be
attached above the second metal connector
on each pole. Hold both ends of one tie-down
in one hand and find the center with the other
hand. Wrap the rope around the pole and insert
the ends through the loop, forming a slip knot.
(Figure 5a) Pull the knot tight. (Figure 5b) Repeat
this step for the other three poles (Remember:
tie-downs should be attached above the second
metal connector on each pole. Attaching the
tie-down above the connector will keep the knot
from sliding down the pole.)
Step 6:
Cover the Pond & Garden Protector with the net.
(Figure 6)
Step 7:
Next install two net clips on each pole.
Clips should be evenly spaced, two per pole.
Begin by installing one clip closest to the Center
Pole Receptor under the first metal connector.
Pull the excess slack out of the net before you
attach the clip. Wrap the clip around the pole and
squeeze the clip to fasten (Figure 7). Repeat this
step by securing the second clip on the pole at
the bottom of the lower metal connector.
Securing the clips on the bottoms of the metal
connectors keep them from sliding up.
Step 8:
Place Pond & Garden Protector over the water
garden.
Step 9:
Secure the Pond & Garden Protector in place
using the tie-downs and the four large tent
stakes (Figure 9). Working from a short side of the
rectangular base, pull one of the tie-downs from
the pole on the left and one from the pole on the
right, towards the ground in the middle of the
two poles. Drive a tent stake into the ground, pull
the excess slack out of the tie-downs and attach
the tie-down to the tent stake. Move to the
opposite side and repeat. Once the two ends
have been secured, the two remaining sides
should be secured in the same fashion.
Figure 5a
Figure 5b
Figure 6
Figure 7
Figure 9
3