Atlantic PV1700 Ürün Kılavuzu - Sayfa 8

Çim ve Bahçe Ekipmanları Atlantic PV1700 için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. Atlantic PV1700 12 sayfaları. Oasis series skimmer, filterfalls, pump vault, fastfalls
Ayrıca Atlantic PV1700 için: Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır

When you are satisfied with the placement of the

FastFalls, remove the unit and install the liner and

underlayment, being careful not to disturb the

level base. Place the FastFalls on top of the liner

in its original position. Check the unit for

level to ensure that nothing has changed.

Once the FastFalls is level and positioned

correctly, place a couple of large stones

on top of the FastFalls. This will ensure that

the FastFalls does not move when backfilling

and attaching liner.

FastFalls Liner and Plumbing Attachment

Hold the liner up against the flat panel on the back of the FastFalls enclosure. Leave some

excess slack in the liner below the inlet. This will help alleviate any future strain on the liner

connection. Make sure the back surface of the FastFalls, and the back side of the liner is

clean and free of debris. Once you are satisfied with the position of the liner, lower it down

and prepare to apply the silicone sealant.

Apply Silicone Sealant in a

continuous, consistent bead

along the center of the threaded

inserts. Once completed, return

the liner to its dry-fit position.

Attach the supplied flange to

the FastFalls, starting with the

top screw first, working around

the flange. If needed, use an awl

or nail to pierce the liner before

inserting the screws. Do not fully

tighten any screws until all of

the screws have been installed.

Once completed, trim away the

liner on the inside of the flange

to expose the threaded inlet.

Tighten flange screws with a hand held screwdriver only. Over tightening the screws

could strip out the inserts or crack the liner flange. The screws need only to be snug

for the silicone to make a seal.

Apply silicone on the threads of the Male Thread Adaptor (MTA). Screw the MTA into the

inlet until tight. Use PVC Glue (not included) to glue the PVC flex hose into the MTA.

MTA