Electrolux FHWC3655LSA Kullanım ve Bakım Kılavuzu - Sayfa 6
Havalandırma Davlumbazı Electrolux FHWC3655LSA için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Electrolux FHWC3655LSA 13 sayfaları. 30 and 36 free-standing range hood
Ayrıca Electrolux FHWC3655LSA için: Kullanım ve Bakım Kılavuzu (13 sayfalar), Kullanım ve Bakım Kılavuzu (13 sayfalar)
Sayfayı Yazdır
Installin
the hood
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i
ii,%_%%%%%,
iii%ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_i:I_
mnstalling
the hood
Preparation
®
®
Determine the exact location of the range hood.
Plan the route for venting exhaust to the outdoors
(f g. ® ).
Plan the power connection
prior to installation so
that electrical wiring will not be visible afterwards.
House
wiring
location:
The junction
box is
located on the top right side of the hood. Wiring
should enter the back wall at least 20" above
the bottom of the installation height, and within
3-3/8" to 4-3/4" of the right side of the centerline
(fig. O/®).
fig.
O
__--
FOR CEILING VENT DUCTING
4-3/4"
circle
center to wall
_-7--__ /
/
i
_Ceiling
8-1t2"dia. hole (
=
FOR
X--
_-
WALL ..._/' "_____
Circle center at 233/4"
VENT
k
)_ve
the marked bottom
DUCT
_
/
pencil line,
_LL_
_rizontal straight
1
"_
pencil line
•
Use the shortest
and straightest
duct
route
possible.
The
wall
breakthrough
must
be
carried
out
by a professional
prior
to installing
the
range
hood.
Pay attention
to the
length
of
the
exhaust
hose
when
planning
the
wall
breakthrough.
The exhaust
hose
must
reach
the outer edge of the wall without
any kinks.
Important!
If the exhaust hose leads through an
outer wall, install a wall cap with damper or roof
cap at the exterior opening (not delivered). This
can be installed by the professional that performs
the wall breakthrough.
If open fireplaces are operated in the same room,
o
o
ask your local chimney sweeper about the local
regulations prior to installation.
If you are renting, then approval must be obtained
from the owner of the property.
Attention!
In order for the range hood to reach
optimal performance,
install it over the middle of
the cooking area.
The following accessories are required to mount
the range hood (not included):
-,
Exhaust duct
-,
Power drill with 3/16" and 1/8" bits
-,
Screwdriver
-,
Level
-,
Cable detector
-,
Measuring tape
-,
Duct tape
fig.
©
8to 9
ft
Installation
: Center line
height
36"
Ducting
installation
guidelines
For safety reasons, ducting should vent directly
outdoors (not into an attic, underneath the house,
into the garage or into any enclosed space).
Keep duct runs as short and straight as possible.
Duct fittings (elbows and transitions)
reduce air
flow efficiency.
Back to back elbow and "S" turns give very poor
delivery and are not recommended.
A short straight length of duct at the inlet of the
remote blower gives the best delivery.
Transition
to duct from the integral blower or
remote duct transition as close to the downdraft
as is possible.
Use a suitable 6" round duct.
Flexible metal round ducts should only be used
when no other duct fitting exists. Limit use to
short lengths and do not crush when making
corners.