Electrolux HOOT21E Kullanıcı Kılavuzu - Sayfa 18

Havalandırma Davlumbazı Electrolux HOOT21E için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux HOOT21E 24 sayfaları. Built-in hood for electric oven
Ayrıca Electrolux HOOT21E için: Kurulum Kılavuzu (32 sayfalar)

Sayfayı Yazdır

F.2.5

UV-C Lamps - cleaning and/or

replacement

The hood is equipped with UV-C Lamps. They are

located inside a central technical compartment,

behind the Labyrinth Filter, in front of the hood.

Periodic cleaning or restore are recommended. A

pop-up window appears automatically on the oven

display when cleaning or replacement is required.

Remove the labyrinth filters, starting from the

middle one, raising and pulling the lower part

outwards (see F.2.1);

Open the central technical compartment by

undoing the screws fixing the cover;

Loosen the screws, move up the retaining plate;

Remove four electrical connectors (pay attention

the right position for further refit);

Remove the cassette that contain TiO2 Filter

and UVC lamps;

Remove TiO2 Filter from cassette (see F.2.4);

Wear a cotton gloves to don't touch directly the

glass, this will help maximize lamp life;

Remove the UV-C Lamps from cassette one by

one;

Clean UV-C lamps one by one with a dry cotton

cloth; only in a very dirty case, you can use a

paper towel little soaked with alcohol only;

In any case, pay attention don't damage the

external glass and the electrical connectors;

10. Refit it one by one on their previous cassette's

place;

11. Refit TiO2 Filter on cassette;

12. Refit the UV-C lamps and TiO2 cassette in its

place. Make sure to refit it properly;

13. Move down the retaining plate and tighten the

screws,

14. Refit the four electrical connectors on previous

place;

15. Fixing the cover central technical compartment

by the screws;

16. Refit the labyrinth filters. Follow the operating

instructions in the chap F.2.1. Make sure to refit

them properly;

17. Reset timer of maintenance following chapter

F.3.

To replace the UV-C Lamps, follow previus

operations except the one described at point nr.9.

231007 OM_HO_04_ELUX_EN.docx -