Electrolux ICON RH36WC60GS Kurulum, Kullanım ve Bakım Kılavuzu - Sayfa 13

Havalandırma Davlumbazı Electrolux ICON RH36WC60GS için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım Kılavuzu indirin. Electrolux ICON RH36WC60GS 21 sayfaları. 30” et 36” hotte aspirante
Ayrıca Electrolux ICON RH36WC60GS için: Teknik Özellikler (2 sayfalar), Fabrika Parça Kataloğu (4 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (22 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (22 sayfalar), Kullanım ve Bakım Kılavuzu (44 sayfalar), (İngilizce) Kurulum, Kullanım ve Bakım Kılavuzu (22 sayfalar), (Fransızca) Manual D'installation, Utilisation Et D'entretien (22 sayfalar)

Sayfayı Yazdır
Electrolux ICON RH36WC60GS Kurulum, Kullanım ve Bakım Kılavuzu

Making the electrical connections

Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V
120 V
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
120 VAC, 15 or 20 Amp cir
120 V
120 V
AC, 15 or 20 Amp circuit r
AC, 15 or 20 Amp cir
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failur
Failur
e to do so can r
e to do so can r
esult in death or electrical
esult in death or electrical
Failur
Failure to do so can r
Failur
e to do so can r
e to do so can result in death or electrical
esult in death or electrical
esult in death or electrical
shock.
shock.
shock.
shock.
shock.
• Remove junction box cover and knockout on the
top left side.
• If not already done, install 1/2" conduit connector
in j-box.
cuit r
cuit r
equir
equir
ed.
ed.
cuit requir
cuit r
equired.
equir
ed.
ed.
Knockout
Junction box
cover
Installing the hood
House
wiring
U.L. listed
wire nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.

Mounting the glass canopy

Mounting the glass canopy
Mounting the glass canopy
Mounting the glass canopy
Mounting the glass canopy
• With the hood mounted on the wall slide the glass
canopy over the glass supports.
• Insert the glass brackets.
• Insert two screws into the bracket holes, drive the
screws by hand.
13
13
13
13
13
Metal electrical
conduit