Atlantic Technology T70 PBM Kullanım Kılavuzu - Sayfa 11

Subwoofer Atlantic Technology T70 PBM için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Atlantic Technology T70 PBM 12 sayfaları. High performance powered subwoofer

Model T70 PBM Specifications
Specifications are those in effect at the time of printing. Atlantic Technology reserves the right to change specifications or designs at any time without notice. Dolby Digital, AC-3,
Dolby Stereo and Dolby Pro Logic are trademarks of Dolby Laboratories Licensing Corporation. DTS is a registered trademark of DTS Technology.
Subwoofer Troubleshooting Guide
Once your subwoofer is set up, you should have many years of maintenance free enjoyment from your
system. However, if you should encounter a problem, refer to the following guide to help find the
solution. If the problem persists, please contact your local authorized Atlantic Technology dealer.
Problem
No bass output
Audible buzz
or hum
Weak bass
Weak bass: vague stereo image
Type/Features
Driver
Amplifier Power
Amplifier Distortion <0.025%
Frequency Response 25-150 Hz 3dB (in room)
Peak output (SPL)
Dimensions
Weight
Possible Cause
AC power cord unplugged or plugged into a non-working outlet.
Input cables not securely connected or defective.
Input cable not securely connected or defective.
Single HI LEVEL input connected to the RIGHT channel only.
Ground loop through antenna or cable TV system input.
Subwoofer too far from the wall.
VARIABLE INPUT LEVEL set too low.
Input source connected to HI LEVEL inputs is wired out of phase.
Powered Subwoofer with Sealed Acoustic-Suspension Enclosure
24 dB/Octave variable crossover
Line-level stereo inputs and thruputs
High-level stereo inputs and high-level, high-pass bass filtered outputs
Absolute phase invert switch
Auto signal sensing on/off
(1) 10" long-throw woofer, 2", 4-layer vented voice coil, vented
motor system
125 Watts RMS discrete linear Class A/B power amplifier
103dB
11.375in x 16.5in x 14.9in; 290mm x 420mm x 380mm
37.5lbs.; 17kg.
Possible Solution
Plug into a working outlet.
Check all connections, then try another input cable.
Check all connections, then try another input cable.
Connect to the LEFT input channel.
Test by disconnecting antenna and/or cable system input leads.
If hum goes away, install isolation balun(s) at that point.
Move the subwoofer closer to a wall or corner.
Turn control up somewhat.
Check speaker wire connections and reconnect in proper phase.
11
Atlantic Technology
®