Atlantic Technology SA-380 Kullanım Kılavuzu - Sayfa 11
Amplifikatör Atlantic Technology SA-380 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Atlantic Technology SA-380 12 sayfaları. Inwall subwoofer system thx ultra mono subwoofer amplifier
Sayfayı Yazdır
Instruction Manual
Caring For Your Subwoofer
IMPORTANT: Save Your Boxes! If you can do so, save the carton,
packing pieces and plastic bags that came with your subwoofer.
They will be useful in case you move or have to ship your subwoofer
for any reason. In any case, save all packing materials until you are
certain that the system has suffered no damage in shipment. If you find
such damage, either visible or internal, contact your dealer immediately
for the proper return procedure.
Problem
No bass output
Audible buzz or hum
Weak bass: vague stereo image;
especially when using dual sub/amp setup
Specifications
RMS Power (before limiting and servo)
Signal to Noise Ratio (-90dB hum)
Frequency Response (typical, in room)
Low Level Input Sensitivity
Low Level Input Impedance
Power Supply Storage
Toroidal Transformer
Peak Output Stage Current
Dimensions W x H x D
Weight (lbs)
Possible Cause
AC power cord unplugged or
plugged into a non-working outlet.
Input cables not securely
connected or defective.
Input cable not securely connected
or defective.
Ground loop through antenna or
cable TV system input.
Acoustic phase of subwoofer(s) doesn't
match rest of system.
380 W @ 4 Ohms, <.025%THD
-97dB @ full power
20-150 Hz ±3 dB
250mv @ full output, 100Hz
15K Ω
22K microfarads
400VA
40amps rated
17" x 1.5" x 11.5" (430 x 40 x 330mm)
18lbs. (8.2kg)
Subwoofer Troubleshooting Guide
Once your subwoofer is set up, you should have many years of mainte-
nance free enjoyment from your system. However, if you should encoun-
ter a problem, refer to the following guide to help find the solution. If the
problem persists, please contact your local authorized Atlantic Technol-
ogy dealer.
Possible Solution
Plug into a working outlet.
Check all connections, then try another
input cable.
Check all connections, then try another
input cable.
Test by disconnecting antenna and/or cable
system input leads. If hum goes away, install
isolation balun(s) at that point.
Check speaker wire connections and/or
phase switch settings.
Specifications
11