ADVANCED Network Devices AND-BTN-KIT-1 Kurulum

Saat ADVANCED Network Devices AND-BTN-KIT-1 için çevrimiçi göz atın veya pdf Kurulum indirin. ADVANCED Network Devices AND-BTN-KIT-1 4 sayfaları.

OVERVIEW

The AND Call Button Kit (AND-BTN-

KIT-1) includes a momentary push

button with wall plate. The button

connects to the general purpose

input of an AND device.

NOTE: LEGACY DEVICE

COMPATIBILITY CONSIDERATION

Older devices with a MAC address

less than 20:46:F9:05:30:00 require

an AND-PIA-2 card (AND-PIA-2D for

IPSIGNL-RWB or IPCDS-RWB) to

interface with the button, except for

the ZONEC2 which can directly

connect to the button. Contact AND

tech support ([email protected]) for

information

determining product compatibility.

Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004

Call Button Kit Installation

WIRING

Use 18 - 22 AWG stranded or solid

core wire for connection between

the button and the AND device.

Strip the device end of the wires to

8mm. Connect the wires to the two

inputs on the GPIO 0 terminal of

the device by pushing down on the

terminal tabs and inserting the

wires into the terminal holes.

Polarity of the wires does not

matter. Strip and connect wires at

other end of run to screw terminals

of button.

sensing, press the button.

help

• 847-463-2237 •

www.anetd.com/user-support/

Warning: Remove power prior to

installation to avoid possible damage

of components.

To trigger the input

(AND-BTN-KIT-1)

v1.5