Bosch Series 4 Kullanım Kılavuzu - Sayfa 6

Sayfayı Yazdır

Causes of damage

]Causes of damage

G eneral information

C a u s e s o f d a m a g e

Caution!

Accessories, foil, greaseproof paper or ovenware on

■

the cooking compartment floor: do not place

accessories on the cooking compartment floor. Do

not cover the cooking compartment floor with any

sort of foil or greaseproof paper. Do not place

ovenware on the cooking compartment floor if a

temperature of over 50 ºC has been set. This will

cause heat to accumulate. The baking and roasting

times will no longer be correct and the enamel will

be damaged.

Aluminium foil: Aluminium foil in the cooking

■

compartment must not come into contact with the

door glass. This could cause permanent

discolouration of the door glass.

Water in a hot cooking compartment: do not pour

■

water into the cooking compartment when it is hot.

This will cause steam. The temperature change can

cause damage to the enamel.

Moisture in the cooking compartment: Over an

■

extended period of time, moisture in the cooking

compartment may lead to corrosion. Allow the

cooking compartment to dry after use. Do not keep

moist food in the closed cooking compartment for

extended periods of time. Do not store food in the

cooking compartment.

Cooling with the appliance door open: Following

■

operation at high temperatures, only allow the

cooking compartment to cool down with the door

closed. Do not trap anything in the appliance door.

Even if the door is only left open a crack, the front of

nearby furniture may become damaged over time.

Only leave the cooking compartment to dry with the

door open if a lot of moisture was produced whilst

the oven was operating.

Fruit juice: when baking particularly juicy fruit pies,

■

do not pack the baking tray too generously. Fruit

juice dripping from the baking tray leaves stains that

cannot be removed. If possible, use the deeper

universal pan.

Extremely dirty seal: If the seal is very dirty, the

■

appliance door will no longer close properly during

operation. The fronts of adjacent units could be

damaged. Always keep the seal clean. Never

operate the appliance if the seal is damaged or

missing. ~ "Cleaning" on page 18

Appliance door as a seat, shelf or worktop: Do not

■

sit on the appliance door, or place or hang anything

on it. Do not place any cookware or accessories on

the appliance door.

Inserting accessories: depending on the appliance

■

model, accessories can scratch the door panel

when closing the appliance door. Always insert the

accessories into the cooking compartment as far as

they will go.

Carrying the appliance: do not carry or hold the

■

appliance by the door handle. The door handle

cannot support the weight of the appliance and

could break.

5Installation and connection

T his appliance is only intended to be fully fitted in a

I n s t a l l a t i o n a n d c o n n e c t i o n

kitchen. Observe the special installation instructions.

Do not install the appliance behind a decorative door or

the door of a kitchen unit, as this may cause the

appliance to overheat.

Electrical connection

Only licensed specialists may connect the appliance.It

is important that you comply with the requirements of

your electricity supplier.

Any damage arising from the appliance being

connected incorrectly will invalidate the warranty.

Caution!

If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

The appliance must be disconnected from the power

■

supply whenever installation work is being carried

out.

The appliance fulfils the requirements of protection

■

class I and may only be connected to an earthed

socket.

The mains power cable must be at least type

■

H05 V V-F 3G, 1.5 mm².

Warning – Danger of death!

There is a risk of electric shock if you touch live

components.

Always make sure your hands are dry when you

■

touch or hold the mains plug.

Only pull out the mains cable by taking hold of the

■

plug and removing the plug; never pull it out by the

mains cable itself, as this could damage it.

Never unplug the mains plug when the appliance is

■

in operation.

Please note the following information and ensure that:

Notes

The mains plug fits the socket.

■

The cable cross section is adequate.

■

The earthing system is properly installed.

■

The mains cable is only replaced by a qualified

■

electrician (if this is necessary).Spare mains cables

can be ordered from our after-sales service.

No power strips/multi-way connectors or extension

■

cables are used.

If using a residual current device, only use one that

■

bears the mark

The presence of this mark is the only way to be sure

that it fulfils all the applicable regulations.

The mains plug can be accessed at all times.

■

The mains cable is not kinked, crushed, modified or

■

severed.

The mains cable does not come into contact with

■

heat sources.