Electrolux RS-600/S Kurulum ve Kullanım Kılavuzu - Sayfa 5
Havalandırma Davlumbazı Electrolux RS-600/S için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Electrolux RS-600/S 5 sayfaları.
Sayfayı Yazdır•
Hang the chimney (2) on the lower bracket (4) (fig. ). Fix the
upper chimney (2) on the upper bracket (3), and secure on
both sides with the 2 remaining short screws (9) (fig. ).
•
Fine tune the chimney height, and tighten all screws. Check
tight fit of all parts.
Bridging larger distances
•
Bridging larger distances to the outdoors can be achieved by
installing an external motor inside the exhaust duct. To do
this, consult an electrician.
Installation without exhaust duct
•
If you do not have an outlet to the outside, the exhaust pipe
is not required and the installation is similar to the one shown
in the Installation with exhaust duct section.
6. OPERATION
•
Switch on the appliance at the switched fused connection
unit. The appliance is ready for operation.
Functions
Switch
Function
0
Appliance off
1
Low speed (pilot lamp lit)
2
Medium speed (pilot lamp lit)
3
High speed (pilot lamp lit)
Switching light on/off
7. MAINTENANCE
•
Before cleaning, switch the appliance off and disconnect the
cooker hood from power supply.
•
Clean the appliance in the following intervals:
Use a soft cloth moistened with hand-warm mildly
soapy water or household cleaning detergent. Never
use metal pads, chemical, abrasive material or stiff
brush to clean the appliance.
Metallic anti-grease filter: The filter collects grease,
smoke and dust so the filter is directly affecting the
efficiency of the cooker hood. If not cleaned, the
grease residue (potential flammable) will saturate on
the filter. Clean it with household cleaning detergent.
Important: Clean the filter every month to
prevent risk of fire.
RS-600 (CHS60SS)-GB-05.indd 5
Light bulb replacement
The lighting system fitted to the hood is just a
supportive light. In any case, it can not substitute for
the main lighting in the kitchen.
•
Switch the appliance off and disconnect the power supply.
•
In order to replace light bulbs, both metallic anti-grease filters
should be detached first.
•
Press the locks and pull the filters downward.
•
Screw one or both of the light bulbs from the holder and
replace by new light bulb(s) of the same type, max. 40W
(E14).
•
Replace the metallic anti-grease filters and make sure they
lock in place.
8. TROUBLESHOOTING
Fault
Cause
The appliance is
not hung properly
on the brackets.
Excessive
vibration.
The fan blade is
damaged.
The fan motor is
not fixed tightly.
The fan blade is
jammed.
Light on, but fan
does not work.
The motor is
damaged.
Light bulb broken.
Both light and fan
do not work.
Power connection
loose.
Distance between
the appliance and
the cooking place
Suction
too large.
performance
not good.
Metallic anti-
grease filter is dirty.
9. TECHNICAL DATA
Power supply
Power consumption – Fan
Power consumption – Luminary :
Power consumption – Total
Protection class
Light bulb
10. ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for
recycling advice.
5
Solution
Take down the
appliance and
check it is properly
fixed.
Switch off the
appliance. Repair
to be carried out
by qualified service
personnel only.
Replace with a
bulb with correct
rating.
Check power
supply.
Readjust the
distance to:
Gas cookers:
70cm
Electric cookers: 66cm
Coal/oil cookers: 8 0cm
Clean filters (see
Maintenance
chapter).
:
220-240V~ 50Hz
:
140W
2 x 40W
:
220W
:
II
:
Max. 40W (E14)
6/8/2010 9:31:04 AM