Electrolux ZHT 610 Kurulum, Kullanım ve Bakım El Kitabı - Sayfa 6

Havalandırma Davlumbazı Electrolux ZHT 610 için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım El Kitabı indirin. Electrolux ZHT 610 10 sayfaları.

Sayfayı Yazdır

Electrolux ZHT 610 Kurulum, Kullanım ve Bakım El Kitabı

3.2 – Wall unit installation

Using the cardboard template, mark

and drill the bottom of the wall unit,

(see instructions on the template).

Fasten the hood from inside the unit

using four screws 4,2 x 44,4

(supplied) (fig.7). For suction hoods,

the wall unit must be drilled to allow

for the air discharge duct. Filter hoods

do not require this type of drilling

operation since the air is recycled into

the room through vents situated on

the front of the hood.

3.3 - Connecting suction or filter hoods

1 - Connecting suction hoods (air is discharged into the atmosphere)

The hood comes with two air outlets, a plastic cover

fitted in the rear hole and a flange to be fitted

according to the solution chosen: top discharge (fig.

8), rear discharge (fig. 9). In case of installation with

rear discharge, fit the plastic cover in the top hole

and the flange in the rear hole. Using a pipe Ø 100

o 120 mm, connect the air discharge flange to the

external discharge duct. Open the grid panel by

pressing inwards on the knobs (fig. 10), check that

the lever (hood with one motor) or the handle (hood

with two motors) points to the ducting mode position

(fig. 11), remove the charcoal filter, if any, by turning

the handle anti-clockwise (see par.3.3 2 part 2°).

Respect warning 2.1

1 0

Part 1 - INSTALLATION INSTRUCTIONS

8 8

9 9

7 7