3M 6239301 Kurulum ve Çalıştırma Talimatları Kılavuzu - Sayfa 16
Su Filtrasyon Sistemleri 3M 6239301 için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Talimatları Kılavuzu indirin. 3M 6239301 20 sayfaları. Reverse osmosis system
Ayrıca 3M 6239301 için: Kurulum ve Çalıştırma Talimatları Kılavuzu (20 sayfalar)
Sayfayı Yazdır
Routine Maintenance Cartridge Change out Instructions (Pre-Filter and RO Membrane Cartridge)
RO Membrane Cartridge (green label) Replacement Cont.:
4. Remove sanitary cap from new RO membrane cartridge. Ensure o-rings are seated into their grooves. Remove drain fitting plug from new RO
membrane cartridge. Install with a quarter turn to the right until RO membrane cartridge comes to a complete stop.
NOTE: RO membrane cartridges are keyed to fit in proper location only.
5. Insert new flow control into the elbow (included with new RO membrane cartridge). Install this sub assembly into the drain fitting (cartridge
bottom) See Figure 3.
6. Connect reject line into elbow.
7. IMPORTANT: Complete System Start Up and Membrane Flushing procedure before system is brought back into use. See pages 10-11.
This product is outfitted with a user friendly 'Push In' connector at the vent valve. Proper use of the connectors is shown in the figure below.
It is most important that the tubing selected for use with these connectors be of high quality, exact size and roundness, and with no surface
nicks or scratches. If it is necessary to cut the tubing, use a plastic tubing cutter or sharp razor knife. Make a clean square cut. Should a
leak occur at a "Push-In" connector, the cause is usually a problem with the tubing.
To Fix:
1. Relieve pressure
4. Reattach tubing
To Attach Tubing
Push tubing straight in as far as it
will go
Figure 9 (How to Use "Push-in" Connectors)
2. Release tubing
3. Cut off at least 1/4" from end
5. Confirm connection is leak free
Tubing is secured in.
To Release Tubing
Push in collet to release tubing.
16
Pull tubing straight out.