Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Screwdriver bit*
2 Tool holder
3 Locking sleeve
4 "Power Light"
5 Soft grip
6 Battery unlocking button
7 Battery*
8 Rotational direction switch
9 On/Off switch
10 Universal bit holder*
*The accessories illustrated or described are not
included as standard delivery.
Noise/Vibration Information
Measured
values
EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 92 dB(A); sound power level
103 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60745:
For tightening screws and nuts of maximum permitted
size: Vibrational emission value a
2
tainty K = 1.5 m/s
.
The vibration emission level given in
WARNING
this information sheet has been
measured in accordance with a standardised test
given in EN 60745 and may be used to compare one
tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information
sheet. This could lead to a significant underestimate
of exposure when the tool is used regularly in such a
way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the times
when the tool is switched off and when it is running
but not actually doing the job. This may significantly
reduce the exposure level over the total working
period.
F 000 622 262 . 25.03.07
determined
according
2
= 8.0 m/s
h
Technical Data
Cordless Impact Screw-
driver
Article number
Rated voltage
No-load speed
Impact rate
Maximum torque, hard
screwdriving application
according to ISO 5393
Bolt size
Max. screw dia.
Tool holder
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
to
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 60745 according
to the provisions of the directives 89/336/EEC,
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
, uncer-
Engineering
04.07.2006, Robert Bosch GmbH, Power Tools Division
D-70145 Leinfelden-Echterdingen
Assembly
Battery Charging (see figure A)
Use only the battery chargers listed on the
accessories page. Only these battery chargers
are matched to the lithium ion battery of your
power tool.
The Li-ion battery is protected against deep discharg-
ing by the "Electronic Cell Protection (ECP)". When
the battery is empty, the machine is switched off by
means of a protective circuit: The inserted tool no
longer rotates.
WARNING
machine has been automatically switched off.
The battery can be damaged.
GDR 10,8 V-LI
PROFESSIONAL
3 601 J09 0..
V=
rpm
bpm
Nm
mm
¼" hexagon socket
kg
Dr. Eckerhard Strötgen
Head of Product
Certification
Do not continue to press the
On/Off
switch
10.8
0–1800
0–3000
100
M4–M12
8
1.0
after
the
English | 21
Sayfayı Yazdır